0
The process is actually pretty simple. You do not need to remove any panels, bolts are anything but the actual switch. Grab some needle nose pliers, i prefer to use duckbill, but not everyone has them, and pull out the old switch, there should be a lip you can grab just below the trim. It took a little fanagling for me, but i got it. The whole switch will come out and there should be an empty socket now. To reinstall the switch, simply press the new one into the socket. The process is actually pretty simple. You do not need to remove any panels, bolts are anything but the actual switch. Grab some needle nose pliers, i prefer to use duckbill, but not everyone has them, and pull out the old switch, there should be a lip you can grab just below the trim. It took a little fanagling for me, but i got it. The whole switch will come out and there should be an empty socket now. To reinstall the switch, simply press the new one into the socket.
What else can I help you with?
What causes hazards to go on by themselves on a Chevy blazer?
Faulty hazard switch
How long does it take to change a transfer case switch on a Chevy blazer?
5 min
Is there a fuel pump reset switch for a 1992 Chevy blazer s 10?
No. A Chevy Blazer does not have a reset switch.
How do you manually shut off the kill switch on a 1996 Chevy blazer s10?
There is no "kill switch" on that Chevy Blazer.
1995 Chevy Blazer and the hazard the turn signal and brake lights do not work Does anybody know why?
The hazard switch and the turn signal and brake lights are all incorparated, chances are the 3-1 switch is broke internally check all fuses
Location of inertia switch on a 2000 Chevy blazer?
A 2000 Chevy Blazer is a GM vehicle. Vehicles made by GM do not come equipped with an inertia switch.
What year did the Chevy Blazer switch to r134a?
1994
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Where is inertia switch on 1998 Chevy S 10 Blazer?
where is the fuel pump inertia switch located on a 2000 blazer
Where is the oil pressure switch located on a 1998 Chevy Blazer?
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
How do you change a timing chain in a 1996 Chevy blazer?
1996 Chevy blazer timing chain
How do you change the timing belt on a 1996 Chevy Blazer?
The 96 Chevy Blazer does not have a timing belt.
