I just purchase a f150 that needs a new ignition switch and the man at auto zone gave me directions with pictures and diagrams, I hope this is of some use. Good Luck!
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
I had a similar problem on a Ford truck and it turned out to be the ignition switch. The truck would start just fine but when I released the ignition key the truck would die. I replaced the switch and problem was gone.
To change the ignition switch on a 1989 Buick Electra, first disconnect the battery to ensure safety. Remove the steering column cover to access the ignition switch, then detach the wiring harness and any screws securing the switch. Replace the old switch with a new one, reattach the wiring, and reassemble the steering column cover. Finally, reconnect the battery and test the new ignition switch to ensure it's functioning properly.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
LOCKSMITH CHEAP QUICK
how do you install new ignition switch on 1989 chevy G10 van?
To change the ignition switch on a 1989 Beretta, start by disconnecting the battery to ensure safety. Remove the steering column covers by unscrewing them and then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch, unbolt it, and replace it with the new ignition switch. Finally, reassemble the steering column covers, reconnect the battery, and test the new switch to ensure it functions correctly.
how can you start a '89 mercury cougar with a broken ignition switch?
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
it does not have an inertia switch.
To make it easy yes, otherwise you have to drill out the old one.
To remove the ignition switch on a 1989 Toyota pickup, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws that hold it in place. Next, locate the ignition switch assembly, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the ignition switch out and replace it if necessary.