answersLogoWhite

0


Best Answer

Use the link below. It may help.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the ignition switch on a 1998 Oldsmobile Intrigue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Wiring diagram for 99 Oldsmobile intrigue ignition switch?

i need a wiring diagram with pictures to help put my ignition switch back together on my 99 olds intrigue


Were is the Oldsmobile intrigue relay switch located?

Were. Is the oldsmobile intrigue relay switch. Loocated


1998 Oldsmobile intrigue the dash board says security and my car will not turn on how can i fix this?

Probably the ignition key switch...I have the same problem


How do you bypass ignition switch on 2000 intrigue?

No


How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?

How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?


Where is ignition switch for 2000 Oldsmobile silhouette?

Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?


Where is the flasher relay located on the 2001 Oldsmobile intrigue?

Behind the hazard switch in the dash


Is there an electrical problem with your 1999 Oldsmobile Intrigue Cruise control doesn't work air conditiioner shuts off rear defogger doesn't work.?

Check ignition switch, common problem.


Where is the neutral safety switch on a 1999 Oldsmobile Intrigue 3.8?

It is in the PRNDL switch on top of the trans. It sends a signal to the ecm.


Where is the fuel reset switch on an Oldsmobile Intrigue?

If you're talking about a Ford-style fuel cutoff switch... there isn't one.


Where is the ignition switch located on 1997 Oldsmobile bravada?

The ignition switch is located inside the steering coulum below the key and tumbler.


How can i replace an ignition switch in a 1989 Oldsmobile cutlas ciera sl?

Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.