0
Same as any other vehicle really.
Lift the truck with a jack when it's cold.
Go underneath with a wrench (15mm) and a oil collection plate.
The oil plug is facing the drivers side door (might vary depending on the engine), watch that you do not loosen the transmissions nut. The oil plug is connected to oil pan.
Remove the plug, this will be hard. Once loosened use your fingers to remove the plug. The oil will come out in a stream at this point. Collect it.
Once all the oil is drained remove the oil filter. This is a difficult task. Replace the filter.
Replace the plug, finger tight with a short wrench turn.
Replace the oil, see your manual for details to the amount.
What else can I help you with?
What size Allen wrench do you need to change oil on a 2002 Chevy s10 manual transmission?
17 mm
Does the oil filter screw into the oil pump on a 2002 Chevy s10?
Directly, no.
How much oil goes into a 2002 Chevy S10 without a new filter?
If you are changing the oil you should ALWAYS change the filter too.
How many quarts of oil in your 2.8L Chevy s10 after oil change?
4.5qrts
What type of oil goes in a 2002 Chevy s10 4.3l?
5W-30
How to change rear oil seal on Chevy S10 PU 4cly 2.5 engine?
Chevy S10 pickup 4cly 2.5 engine,how to change rear oilseal
How many quarts of oil do you put in Chevy s10 after oil change?
4 1/2
What is normal oil pressure on a 2002 Chevy S10 V6?
The normal oil pressure on a 2002 Chevy S10 V6 is around 40 PSI. This will vary slightly depending on the temperature of the engine. Hot at idle in drive, 20 psi is also normal.
What caused engine oil sludge 2000 Chevy s10?
Change the oil every 3k miles.
Amount of oil for a 1996 Chevy s10 pickup?
Engine oil, 4.5 qts with filter change.
Why is the service engine light on your 1991 S10 Chevy blazer?
time for an oil change
What kd of engine oil does a 2002 Chevy s10 use?
A 5W-30 works in most climates.
