answersLogoWhite

0

remove the belt. then in center of the tensioner is a bolt that goes into engine. remove this bolt. then tensioner should come off.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Replace Serpentine belt on Monte Carlo 3.1?

Loosen the tensioner pulley on your Monte Carlo 3.1 liter engine. Slide the tensioner pulley to the right. The serpentine belt can be removed. Put the new serpentine belt on and slide the tensioner pulley to the left.


How do you tighten serpentine belt on 2005 Chrysler 300 2.7 liter v6?

You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.


Where is 2002 ranger 3 liter serpentine belt tensioner?

The serpentine belt tensioner on a 2002 Ford Ranger with a 3.0-liter engine is located on the front of the engine, near the center. It is mounted on the engine block and has a pulley that maintains tension on the serpentine belt. To access it, you may need to remove any components obstructing your view, such as the air intake duct. Use a wrench or a ratchet on the tensioner bolt to relieve tension when removing or installing the serpentine belt.


How to change the timing belts on a 2000 Dodge 3.3 liter V6 engine?

The 3.3L has a timing chain. The serpentine belt (accessory belt) is removed by rotating the tensioner down.


How do you tighten the serpentine belt on a 1997 Plymouth Voyager with a 3 liter engine?

The belt is self adjusted by way of a tensioner.


What is used to apply tension to engine belts on a 4.8 liter Chevrolet?

If it has a serpentine belt it should have an automatic belt tensioner If it doesn't have a serpentine belt then alternator should be the adjustment/pivot point


How do you loosen the serpentine belt on a 1998 dodge voyager with a 3.0 liter engine?

The pulley bellow the alternator is the tensioner. Rotate it with a 15mm to loosen belt.


Help the serpentine belt came off my 1997 jeep 4 liter 6 now what?

tensioner could be loose? bad Harmonic Balancer?


How do you replace a serpentine belt on a 3.8 liter Chrysler engine?

Disconnect the battery. Taking a ratchet and socket rotate the belt tensioner to release the belt. Remove the belt and install the new one. Release the tensioner, and connect the battery.


How do you tighten the serpentine belt on a 93 Saturn SC2 1.9 liter dohc?

You don't, they have a tension pulley that does that automatically. If the belt is too loose, the pulley most likely has to be replaced. Thecommi ::: The serpentine belt is held by tention with a automatic belt tensioner. If the serpentine belt is loose, you will most likely have to replace the entire belt tensioner assembly. the assembly comes with a new pully.


Where is the water pump located on a 1994 Chevy Cavalier?

If you have a 2.2 liter 4 cylinder, the water pump is under the alternator on the passenger side and below the serpentine belt tensioner.


How do you adjust the tension of the Serpentine belt on a 1995 Pontiac Transport with a 3.8 Liter Engine?

Automatic belt tensioner - if not enough pressure replace tensioner Belt has streched too big, and the Automatic belt tensioner is at its limit. The tentioner is how yo remove the belt, so you should feel its tention with your wrench.