0
Open the tailgate
Locate the two Torque Screws that are between the door jam and the light housing. Remove those two screws. I believe it's a T15, not going to swear on the size of the torque driver.
Now for the tricky part...
The light fixture has to come straight out to the rear of the vehicle. There are 4 flanged guides that are very snug. When I took my housing off I had to very carefully use a rubber coated flat screwdriver and gently wedge the housing off. Standing on the side of the vehicle, I insert the flat screwdriver in between the housing and the vehicle and carefully apply pressure. I then went to the back side of the truck and inserted the driver and pryed against the post there gently easing it rearwards. There is probably an easier way but this is how I did it.
Once the housing is away from the vehicle, twist the light bulb housing counterclock wise. Pull out the bulb, insert the new bulb and re-assemble the light fixture.
This advice comes with out any warranties, do this at your own risk, if you break the lightbulb housing it will probably cost you $100 to buy a new one.
What else can I help you with?
How do you change the light bulb for the heater control on a 2006 Tahoe?
To change the light bulb for the heater control on the 2006 Tahoe, you will either need to replace the entire climate control panel or remove and re-solder the bulbs. You can remove the bulbs by first removing the dashboard bezel and then the dash itself. Access the bulbs and pull them out of the control panel. Solder new bulbs into the panel.?æ
How do you change reverse light bulbs on a 2006 BMW X3?
According the the Owners Manual for the X3, any malfunction with bulbs inside the lift-gate (which is where the reverse light is located) need to be brought to a BMW dealer.
How do you change a tail light on a 2006 Mustang V6?
Open the trunk, unfasten the plastic panel at the rear. Taillight bulbs are changed from the inside of the trunk.
Amount of oil needed for a 2006 Ford Expedition?
Type your answer here... how much oil in a ford expedition 2006 with oil filter change
How do you change the rear taillight bulbs and or get the taillight lens off on a 2006 Jeep Liberty?
The 2006 Jeep Liberty rear tail light lens does not come off. The tail light is seal. You can access the tail light lightbulb through the back of the tail light, in the cargo compartment.
How do you turn off the change oil light on the dashboard of a 2006 ford Eddie Bauer expedition?
Its an electrical problem,if your oil is okay.It might be on a recall list.Check with Ford.
How do you change the inside overhead light bulbs in a 2006 town country?
Front console, if it is the leaf shaped lights that you press to turn on, you GENTLY place a screwdriver in and wedge the side out. It is hinged in the front of the lense and should fall out. The bulbs then twist out.
How do you change a light on a steering column in a 2006 Chevy truck?
How do change a light on a steering column in a 2006 chevy truck?
When does the check gauge light come on in a 2006 ford expedition?
According to the 2006 Ford Expedition Owner Guide : The " CHECK GAGE " light comes on if the engine coolant temperature is HIGH or the engine oil pressure is LOW
How do you change a tail light on a 2006 sequoia?
how to change tail light bulb on Toyota sequoia
How many valves does the 2006 Ford Expedition have?
The 2006 Ford Expedition has 24 valves.
What size engine does the 2006 Ford Expedition have?
The 2006 Ford Expedition has a V8 engine.
