If its a Olds Cutlass Supreme, its a fairly easy process. Grab the turn signal stalk firmly near its base. Gently wiggle, and slightly twist while pulling it out. Replace with the new stank and plug in the small plug at the base of the stalk. And your done If you are talking about a Olds Cutlass Ciera, its not a easy process, and I pay to get it done.
how do ypu change front turn signal bulb on Oldsmobile 1991 cutlass cierra
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
how do you change turn signal switch on 1999 toyota camry
How to change blinker switch in a 1994 Firebird ?
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
With the key in the "on" position, turn the signal switch to the turning direction that is ***not***the problem. Check the front and rear of the car so you know which lights are flashing. Now switch the turn signal switch to the bad side and compare the lights that are illuminated (but not flashing) to the side that was working. One or more of the bulbs are out and will not be illuminated. Change that bulb (s).
are you asking about the turn signal bulbs , the turn signal switch or turn signal flasher ?
83 cutlass is either in the steering column (down low away from the turn signal probably, or in the column "multifunction switch", possibly on the floor, but one would assuem you have looked. Relentless
Remove steering wheel (with wheel puller), remove lockplate (with lockplate remover), remove 3 screws that hold turn signal switch, unplug switch at bottom of column, fish out the wires, install new switch, fish in new wires.
it is cool
More information is required to properly answer your question. Are you referring to the turn signal bulb, flasher or switch? SWITCH
THE TURN SIGNAL SWITCH IS BEHIND THE PANEL UNDER THE STEERING WHEEL THERE ARE 2. ONE IS THE TURN SIGNAL AND THE OTHER IS THE FLASHER.