0
What else can I help you with?
How often should you change the oil on your 2005 Chrysler PT Cruiser?
3000 miles
How much oil for a Chrysler PT Cruiser oil change?
The 2.4L uses 4.5 quarts.
How do you tune up a Chrysler PT Cruiser?
Tuning up a Chrysler PT Cruiser can be done at home or by a mechanic. A tune up will consist of an oil change, changing the spark plugs and wires, air filter, and distributor cap.
How do you change the timing belt in a 2001 Chrysler PT Cruiser?
In order to change the timing belt in your PT Cruiser you will need the new tensioner and timing belt covers. Your dealership should have the parts you need
How do you replace the evaporator core on a Chrysler PT Cruiser?
In order to change the evaporator in Pt Cruiser, the entire dash has to be removed, then replace the evaporator, and reinstall the complete dash.
How long does it take to change timing belt on 2001 chrysler pt cruiser?
about 3 hours if you know what you are doing
How many hours does it take to change the water pump on a 2002 Chrysler PT Cruiser?
Book time is about 8 hours.
Chrysler PT Cruiser timing belt when to change?
I Believe it's recommended to change it every 60000 miles (100000km) Every 100,000 miles should be sufficient.
How do you change the thermostat in a Chrysler pt cruiser?
The thermostat on a Chrysler PT Cruiser is changed by disconnecting the upper radiator hose, unbolting the thermostat housing, and removing the thermostat. A new unit can then be put in place and reattached.
What are the recommended change intervals for all the fluids on a 2002 Chrysler PT Cruiser 24L?
Best answer is to check the owner's manual. If car is missing that, go to a Chrysler dealer and pick a manual up. All fluid replacement intervals are spelled out in the manual.
How do you change a dash pad on a 2001 pt cruiser?
Get a newer one without a cracked pad. Then put a carpet kit on it
How do you change the expansion valve on a 2006 Chrysler PT Cruiser?
To change the expansion valve on a 2006 Chrysler PT Cruiser, first ensure the AC system is fully discharged to avoid refrigerant release. Remove the dashboard or access panel to reach the valve, typically located near the evaporator. Disconnect the refrigerant lines and electrical connector from the valve, then unbolt and remove the old valve. Install the new valve, reconnect everything, and recharge the AC system.
