There are 2 screws just inside the bed of the truck that you need to unscrew. The light simply pops out when those are removed. Follow the cable to the plug located near the rear wheel well under the truck and unplug the old light. Run the cable from the new light through and connect it to where the old light was plugged in, screw in the two screws and that's it!
No.... You need to change the whole back tail piece
I was told on 2008 avalanche, should be same on 2007 (not sure) to replace the whole left side valve cover. The PCV is build in in cover ?
You can't you have to replace the whole dashboard instrument cluster assy.
u have to pull the whole distributer to change the pickup coil
You have to cange the whole light.
you CANT U HAVE TO REPLACE THE WHOLE CLUSTER...
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
You don't need to take the whole back panel off to do it!!(learned the hard way) the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.
You have to change the whole rearend and the master cylinder.
no
go to eBay and buy a whole setup for the steering column
Replace the whole light assembly Their are no bulbs it is neon light