0
The 3.5 has coil packs over the spark plugs (called a COP - coil over plug). When I changed my plugs a while back, I visually inspected the coil packs for cracks, and tested the coil resistance. If I remember correctly, they measured a few ohms (can't remember how many, something like 10 ohms), and all were identicle, so I assumed they were OK. If a coil is open, it would measure high resistance. It is unlikely a coil will completely short out, but I'd suspect a coil that reads much different from the others using a DC Volt meter.
What else can I help you with?
How do you bypass ignition switch on 2000 intrigue?
No
My 2000 intrigue will crank but won't start up?
If your 2000 Intrigue cranks but won't start, it could be due to several issues. Common causes include a lack of fuel reaching the engine, a faulty ignition system (like bad spark plugs or ignition coils), or issues with the battery or starter. Additionally, check for any error codes that might indicate problems with sensors or the fuel system. A thorough inspection of these components will help pinpoint the issue.
How do you reset the change oil light in a 2000 Oldsmobile Intrigue?
To reset the change oil light in a 2000 Oldsmobile Intrigue, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn the ignition off and back to the "ON" position to check if the light has reset. If the light is off, the reset is successful.
How do you check the check engine light on a 2000 Oldsmobile intrigue?
With a scan tool.
Where is the ignition switch on 2001 intrigue?
See the link for a 2000 location. The 2001 procedure ought to be about the same.
How do you turn off change oil light 2000 intrigue?
To turn off the change oil light on a 2000 Oldsmobile Intrigue, first, ensure that the oil change has been performed. Then, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset.
How do you replace the ignition switch on 2000 Oldsmobile intrigue?
To replace the ignition switch on a 2000 Oldsmobile Intrigue, first disconnect the battery to ensure safety. Remove the steering column covers and locate the ignition switch, which is typically mounted on the steering column. Unplug the wiring harness from the old switch, unscrew it from its mount, and replace it with the new switch. Finally, reassemble the steering column covers and reconnect the battery.
Why won't the trunk button work on an 2000 Oldsmobile intrigue?
check out the selinoid on the trunk latch
How do you you unlatch wire harness ignition coil cassette for 2000 Oldsmobile intrigue?
To unlatch the wire harness ignition coil cassette on a 2000 Oldsmobile Intrigue, first ensure the ignition is turned off and the battery is disconnected for safety. Locate the wire harness connector at the base of the ignition coil cassette. Gently press the release tab on the connector while pulling it away from the coil to disconnect it. If necessary, use a small flathead screwdriver to assist in releasing the latch without damaging the connector.
How do you repair ignition signal in a 2000 Q45?
To repair the ignition signal in a 2000 Infiniti Q45, first, check the ignition coils and wiring for any visible damage or corrosion. Use a multimeter to test the ignition coil resistance and the continuity of the signal wires. If the coils are functioning correctly, inspect the crankshaft position sensor and its connections, as a faulty sensor can disrupt the ignition signal. Replace any defective components and clear any diagnostic trouble codes before retesting the system.
Why might a 2000 Hyundai Accent engine light be blinking?
A blinking or flashing check engine light in any Hyundai is indicative of a misfire taking place. It could be due to a faulty ignition.coil, leaky ignition wires or bad or worn spark plugs.
Why won't your car shut off?
2000 cougar ,ignition relay has fuse 23 on inside fuse block energizing coils,faulty trunk ajar relay ?
