Bad bearings can usually be "heard" as a roaring noise.On the front, jack up the wheel maybe a foot high - grab the top and bottom of the wheel and push and pull it in and out. A lot of movement can indicate bad or loose bearings.If vehicle has high mileage I'd replace them.Rear is a little harder to determine - the bearings are on the axles.Sometimes an oil leak from the "inside" can be a failed bearing which has damged the axle seal.
The 2003 Dodge Durango has rear wheel drive.
Remove the tire and wheel from your 2003 Kia. Remove the axle end. Remove the wheel bearing retaining nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearings.
Check the vaccum lines to the transfer case
The 2003 Dodge Durango has a 9 ft. 8 in. (116 in.) wheel base.
The 2003 Dodge Grand-Caravan has front wheel drive.
if you have wiring that runs along the front brake hoses to speed sensors at the front wheel bearings, then it has 4 wheel abs.
The 2003 Dodge Grand-Caravan has a 9 ft. 11.3 in. (119.3 in.) wheel base.
2003 Corolla rear wheel bearing sold as complete hub assembly you bolt on.
The 2003 Kia Rio has two front wheel bearings, one for each front wheel. Each bearing is part of the front hub assembly, which supports the wheel and allows it to rotate smoothly. If you need to replace the front wheel bearings, it typically involves replacing both sides to ensure even performance.
Bring it to the dealer!
Yes.
Check to see if your truck has sealed bearings, if it does then the entire spindle unit is replaced as a unit. This was the case on my 2005.