Either with a scan tool or some you can simply unhook both battery cables for 5 mins. Or some you can pull the main fuse or PCM fuse.
the computer is located by the windshield wiper motor
To reset the onboard computer of a 1997 Subaru Outback, disconnect the negative battery cable and let it sit for about 15 minutes. This will clear the memory and reset the onboard diagnostics. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds, then start the vehicle. Keep in mind that this may also reset other settings, so you may need to reprogram your radio and clock.
You can reset the VW Golf 200 onboard computer after servicing with ignition. This will take the system back to the default settings which you can configure to your preference.Ê
It's when the computer's audio card is built in to the mainboard
Under the passenger seat,its a small black box.
Generally, the onboard diagnostics will tell you when you scan the computer codes.
yes you can.
how do u change on board computer BMW 525i 1990 and need a diagram of relay switches
To reset the computer system in a 2000 Jeep Grand Cherokee Laredo, you can disconnect the negative battery cable for about 15 minutes, then reconnect it. This action will clear any temporary error codes and reset the onboard computer. Additionally, you can also perform a reset by using an OBD-II scanner to clear diagnostic trouble codes if you have one available. After resetting, it’s advisable to take the vehicle for a short drive to allow the computer to recalibrate.
The shipboard computer's name is Eddy. The shipboard computer's name is Eddy.
HAL is the onboard computer that goes crazy in the Arthur C. Clarke novel, and movie "2001 - A Space Odyssey".
The timing on the 1.9L escorts are controlled by the onboard computer and CANNOT be adjusted.