answersLogoWhite

0

What else can I help you with?

Related Questions

How do you compress the caliper piston on the rear of a 1988 buick riveria?

I just changed my rotors and pads all the way around. The front pistons compress (used a C-clamp). The rear pistons screw clockwise back into the caliper. Good luck, I hope this helped. Rob in Idaho


How should you go about removing the front brake calipers on a 1988 Buick Regal?

Hey Nina==Take off the wheel then remove the 2 bolts holding the caliper on. Then pry on the caliper to compress the piston and remove the caliper. Hang the caliper with a coat hanger or wire and don't let it hang by the hose. Goodluck Joe


How do you replace rear brakes on a 2007 buick lucerne?

To replace the rear brakes on a 2007 Buick Lucerne, first, lift the rear of the vehicle and secure it on jack stands. Remove the wheel and tire, then locate the brake caliper and remove the caliper bolts to detach the caliper from the rotor. Carefully slide off the old brake pads and replace them with new ones, ensuring to compress the caliper piston back into the caliper housing. Reattach the caliper, replace the wheel, and lower the vehicle before testing the brakes.


How do you compress a rear brake caliper?

Chevy came up with the brilliant idea of turn in calipers a number of years back. Check the inside of the caliper piston cup. If you see a square depression in the center, it is a turn or twist in caliper. DO NOT try to compress it. You'll damage the caliper and increase your brake job costs. Chances are when a brake caliper wont compress it is the type that must be turned and compressed at the same time and requires a special tool that you can borrow from a local chain auto parts like Auto Zone. That was the case on my 96 Buick Riveria rear disk brakes.


How do you get the piston back into the caliper on a 1992 Buick regal?

center the piston cup with a Clamp and turn back slow until the cup set back in place


When was Buick Riviera created?

Buick Riviera was created in 1963.


When you are compressing the rear caliper on a 1992 Buick Regal which way do you turn left or right?

2 the right butt on some of them U have 2 compress the piston AS U are turning IT 2 the right & also the bleeder screw should b open AS not 2 compress old brake fliud backwards into the Master Cylinder.


Buick 1992 riviera?

buick riviera '92. My dad had one and he loved it.


Is a special tool required to remove the rear caliper on a 1994 Buick Regal?

there is no special tool to remove them but one is needed to compress them to get them back on for the rear.


1988 Buick Riviera cold idle adjustment?

choke idle adjustment on 1988 Buick Riviera


Why does Buick Riviera backfires when you accelarate?

i have a 92 buick riviera that putters and chuggs when i accelarate but idles great


Where is fuel pump located on a 1992 Buick Riviera?

Where my fuel pump located on my 1992 Buick riviera