answersLogoWhite

0

You determine how much to bore an engine by how much wear is on cylinder walls if wear exceeds .003 thousands over factory specs then it must be bore to the next .010 thousands over cylinders are only bored in .010 thousands increments and every measure is using factory specs as reference point

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the least you can bore over on a 350 engine?

Its not a matter of how little you can but how much, i would prolly say to be safe 70 or 80. If you bore to much out , the engine will run to hot, thus you need to be very careful and know what you are doing.


What is the measurement of a bore of sixety over on at Chevy 350?

A typical bore size for a Chevy 350 engine is 4.000 inches. A bore measurement of "sixty over" indicates that the bore has been increased by 0.060 inches, resulting in a final bore size of 4.060 inches. This modification is common in engine rebuilds to increase displacement and improve performance.


What is the bore size of a 350 bored 30 over?

A 350 engine typically has a standard bore size of 4.000 inches. When it is "bored 30 over," it means the bore has been increased by 0.030 inches. Therefore, the bore size of a 350 bored 30 over is 4.030 inches.


What bore is a 454 that is 125 over?

A "454 that is 125 over" refers to a 454 cubic inch engine (commonly a Chevrolet big block) that has been bored out 0.125 inches larger than its original bore size. The standard bore for a 454 engine is 4.00 inches, so a 125 over would result in a bore of approximately 4.125 inches. This increase in bore size typically allows for greater displacement and potentially more power, but it can also affect engine dynamics and reliability if not properly managed.


What is a 327 engine bored 060 over?

The bore adds about 10 cu. inches to make it a 337


How much can you bore out a 350 Chevrolet before it will blow up or start to impare performance and life of the engine?

ive heard you can go 60 over (.060)


What is over square Engine?

I'm not a mechanic / technician but as far as I know that is where the engine cylinder bore is larger than the stroke


How much hp dose a 350 bore 30 over have?

Depends on the pistons, camshaft profile, timing, etc... without the rest of the engine info no one can help you.


What is the cylinder size of 350 engine bored 040 over?

4.040". The standard bore is 4.00".


Can you bore a Chevy 350 090 over?

You can bore a 350 .090 over, but the thing is the bore is so big that the cylinder walls are about a hair line thickness apart. In order for the engine to accept the bore and punishment of the shear power, the 350 Block must be casted with extra carbon to strengthen the block.


What is displacement of 350 bored 30 over?

Displacement of "350 bored 30 over" seems to refer to an engine specification, likely indicating a 350 cubic inch engine with a bore size of 30 over (30 thousandths of an inch larger than the standard bore). This means the engine's cylinders have been bored out to accommodate larger pistons, increasing the engine's displacement. The exact displacement can be calculated based on the new bore size and the stroke of the engine. However, additional information, such as the stroke length, is needed for a precise calculation.


How much can you bored out a 318 v8 engine?

Well about .030 and .040 over is pretty good, but .060 over would probably be the most you'd want to go with a 318. If you bore it .080 or .090 over then your asking for trouble.