0
What else can I help you with?
Can you disable the warning chime when you open the door with the key in ignition on a 2001 Pontiac grand am?
Yes, you can disable the warning chime on a 2001 Pontiac Grand Am by locating the chime module, which is typically found under the dashboard. You can either disconnect the module or remove the specific wire that triggers the chime when the door is opened with the key in the ignition. However, be cautious as this may affect other warning sounds in the vehicle. Always consult your owner's manual or a professional mechanic for guidance.
How do I Disable backup warning alarm for an ford escape 2006?
disconnect the cable from the speaker behind the in the rear piller cover
Disable ignition warning chime in Chevrolet?
Pull the key out just a little and the chime will stop. It may be controlledfrom the radio
Can you disable the warning chime when you open the door with the key in the ignition on a 97 crown vic?
You can unplug it. Its under the dash board
How do you disable the ignition key warning bell?
You can do this by locating the dinger under the dash and unplugging it. Once you have this unplugged, it will not make the sound anymore.
How do you disconnect the battery warning light on a Yamaha venture royal?
Dont know. Just want to say that. 
How do you reset rover 75 yellow warning light on a dashboard of a blown build?
Disconnect the battery for 15 mins
How do you reset the yellow engine warning light on a Mazda RX8?
disconnect + battery terminal for 60 seconds then re- connect.
How do you reset a anti skid warning light on a Volvo v70?
To reset the anti-skid warning light on a Volvo V70, start by turning off the ignition and then disconnect the car's battery for about 10 minutes. Reconnect the battery and start the car to see if the light has turned off. If the warning light remains on, it may indicate an underlying issue with the anti-skid system that requires diagnosis and repair. For persistent issues, it's advisable to consult a professional mechanic or a Volvo dealership.
How do you reset power assisted steering sensor dashboard warning light on a 2007 Skoda octavia?
To reset the power assisted steering sensor warning light on a 2007 Skoda Octavia, first ensure that the steering system is functioning correctly. Then, turn off the ignition and disconnect the battery for about 10-15 minutes. Reconnect the battery, start the vehicle, and check if the warning light has cleared. If the light persists, it may indicate a more serious issue needing professional diagnosis.
How do you disable the seat belt warning on a 2004 Lincoln town car?
To disable the seat belt warning system; you must follow the procedure listed under safety restraints. It is on page 88-91 in my manual and involves a whole list of things you have to do while the ignition system is turned to the on position but without the car running.
How do you disable the seatbelt warning on a 2006 Buick Lucerne?
To disable the seatbelt warning on a 2006 Buick Lucerne, you can follow these steps: Start the vehicle and buckle the driver’s seatbelt. Then, turn the ignition off and back on without starting the engine. Finally, unbuckle the seatbelt and buckle it again three times, and then turn off the ignition. This process may vary slightly, so consult your owner’s manual for specific instructions if needed.
