http://www.silveradoss.com/forums/index.php?showtopic=3033
Pull the key out just a little and the chime will stop. It may be controlledfrom the radio
take the key out of the ignition switch.
You can unplug it. Its under the dash board
Yes, you can disable the warning chime on a 2001 Pontiac Grand Am by locating the chime module, which is typically found under the dashboard. You can either disconnect the module or remove the specific wire that triggers the chime when the door is opened with the key in the ignition. However, be cautious as this may affect other warning sounds in the vehicle. Always consult your owner's manual or a professional mechanic for guidance.
The chime module is under the dash on the right of the steering column. To disable the Key-in ignition warning chime simply cut the Black/Pink wire. Its a 7 pin harness going into a large black box. Easy test is to put your key in, open the door and hold the black box with the wire harness still attached next to your ear. Then simply cut the wire to quiet it.
Yes, you can disable the warning chime for a 2001 Ford Escape when the door is opened with the key in the ignition. This typically involves locating the chime module or making adjustments to the vehicle's wiring. However, it's recommended to consult the owner's manual or seek assistance from a professional mechanic to ensure the process is done correctly without affecting other systems.
Find and remove the chime.
How do you program the remote key fob on a 2005 Chevy Malibu maxx
Try calling your Chevy dealer
To disable the seat belt chime on a 2007 Honda Ridgeline, you can use the following method: Sit in the driver's seat with the key in the ignition, turn the key to the "On" position without starting the engine, and then buckle and unbuckle the seat belt three times, ending in the "unbuckled" position. After performing this sequence, the chime should be disabled. If done correctly, you may hear a confirmation beep. Always refer to your vehicle's manual for specific instructions and safety guidelines.
To disable the seat belt chime on a 2008 Corolla S, first, buckle the driver's seat belt and then turn the ignition key to the "On" position without starting the engine. Press the seat belt latch and unbuckle it three times within 10 seconds. The chime should then stop, indicating that the feature has been disabled. If you want to re-enable it, you can repeat the process.
The fuse for the chime is used for other important features, so leave that. disconnecting the speaker is probably the best bet. There is a disable procedure, but I cant get it to work.- 1-turn key to accessory while buckled. 2-after seat-belt light turns of, unbuckle and re-buckle at least 3 times in 60sec. 3- turn key off. there should be a tone to assure you the procedure worked.