answersLogoWhite

0

To disable the airbag alarm in a 2011 Grand Cherokee, you typically need to access the vehicle’s diagnostic system using an OBD-II scanner to clear any fault codes related to the airbag system. Alternatively, you can also disconnect the vehicle's battery for a few minutes, which may reset the system. However, it's important to note that disabling airbag alarms can compromise safety, so it’s advisable to consult a professional technician or refer to the vehicle's manual for proper guidance.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

Where the relay is for the alarm on a 1997 grand Cherokee jeep and where the alrarm is located?

i need to disable jeep factory alarm 1997 cherokee


How do you disable the alarm on 99 jeep grand Cherokee?

The factory alarm can not be disabled, only repaired if malfunctioning.


How do you disable driver side airbag on 1997 Grand Cherokee?

It is illegal to disable an air bag without written permission from the NHTSA


2004 Jeep Grand Cherokee Larado and the alarm is set and no remote how do you disable it so you can start it?

You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.


How do you disable the alarm on a 2000 Pontiac Grand Am SE V6?

how to disconnect alarm in a 2000 pontiac grand am se


Where is the fuse for a factory alarm on a 1993 Grand Cherokee Limited?

on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps


How do you disable alarm security on 1994 jeep grand Cherokee?

To disable the alarm security on a 1994 Jeep Grand Cherokee, you can try disconnecting the battery for a few minutes to reset the system. Additionally, using the key in the driver's side door to unlock it can sometimes disarm the alarm. If the alarm persists, locate the alarm module, usually found under the dashboard, and disconnect it directly. Always consult the owner’s manual for specific instructions related to your model.


How do you completely disable factory alarm on 2002 Grand Cherokee Laredo?

You can not. The "alarm" is an integral part of at least three computers on the Jeep. The pcm (engine), bcm (body functions), and the skim (chip key system).


How do you disable passenger air bag in a 1998 Grand Cherokee?

If you live in the USA, you have to get a form from the National Highway Traffic Safety Administration and have a doctor fill it out proving medical reasoning for airbag disabling.


How do you disable alarm on 1999 Jeep Grand Cherokee Limited OEM?

The alarm system on your Jeep Grand Cherokee is controlled by a small, approximately 3 inch square box that plugs into wiring under your dash on probably the drives side towards the middle. It is black in color and is printed with the words "alarm module. If you unplug that the alarm system will be permanently disabled and starting issues may be resolved as well.


How can you disable or reset the alarm on a 1994 Jeep Grand Cherokee you have tried to lock and unlock all the doors nothing seems to work?

Use the key to unlock the driver side door. This will reset the alarm and the starter cutoff. i took the modul that chimes for doors out and mine stop the alarm.


Does the factory alarm need to be disarmed on a 1998 Jeep Grand Cherokee Larado to install an aftermarket alarm?

no