look for the wire on the seat belt and follow it until you find where it plugs in under the seat and disconnect it.
Get a clip, shhding.com
The factory alarm can not be disabled. It can only be repaired if malfunctioning.
Nope
You follow the law and wear the seatbelt.
No, it is built into the BCM and can not be removed.
From what I have read, there are two options to the consumer:1. Slightly hold the brake while backing (cannot confirm this works)2. Fasten seatbelt or bypass seatbelt safety switch by shorting the two wires under the seat going to the seat belt latch. (I shorted the two wires and it gets rid of the annoying reverse alarm and seatbelt alarm when I just want to take the trash down the road!!! - kills two birds with one stone!)
The best way to disable a Viper brand alarm is to remove it completely and put all wiring back to the stock locations.
There isn't a separate fuse. The warning comes out of the cluster and can not be turned of.
To reset an alarm on a 2001 Dodge Ram 1500, disconnect the battery cable for 10 minutes. Users can also disable the alarm by inserting the key into the door.
It shows that the anit-theft alarm is active.
As nearly as I've been able to tell, you must either use the Smart Key or the keyfob to disable the alarm. Other than that, you can see if the dealer can disable it permanently.
You can not just cut a wire to disable an alarm. You will have to hook that wire back up.