0
How do you disassemble the metal bracket on the rear view mirror on an 2000 Oldsmobile Intrigue to glue to windshield?
I have a 1999 Oldsmobile Intrigue. The rearview mirror on my car has twin maplights, and on the back it says "Donnelly IE 8012001". I'm guessing the 2000 Intrigue uses the same parts. I just re-glued my mirror to the windshield after it fell off. Some other cars use a screw to attach the button to the mirror, but this mirror does not. Instead, I used a flat-head screwdriver to pry the button out of the mirror -- be careful to not to hurt yourself or the mirror. After prying the button out, I studied the mirror, and there doesn't appear to be any other way to remove the button. When gluing the button to the windshield, be careful to figure out which side and orientation the button needs to face before gluing it to the windshield.
What else can I help you with?
How do you remove the battery on a 1998 Oldsmobile Intrigue?
you have to remove the bracket that goes over the top of the battery then its just a matter of unbolting the hold down bracket and the cables
How do you disassemble the inside rear view mirror mount to re-glue to the mount plate back onto the windshield?
Place a standard screwdriver in the slot on the bottom of the bracket. Pull out slightly and slide the windshield mount out of the bracket. The metal band acts as a "spring" that holds the bracket to the windshield mount. What a dumb design..CPEANS 2 in many auto mirrors, the windshield button is held to the mirror bracket with a small Allen screw. Look for this and undo it.
How do you remove an ac compressor for an oldsmobile intrigue 3.5l?
To remove the AC compressor from a 2000-2002 Oldsmobile Intrigue with a 3.5L engine, first, ensure the system is discharged by a professional to avoid refrigerant leaks. Disconnect the negative battery cable, then remove the serpentine belt from the compressor. Next, disconnect the electrical connectors and refrigerant lines from the compressor. Finally, unbolt the compressor from its mounting bracket and carefully remove it from the engine bay.
How do you take off evap canister on 98 Oldsmobile intrigue?
behind left back wheel is where it is mounted. take off the plastic shroud under cas cap. remove from bracket, remove 2 hoses and 1 plug on purge solenoid.
Will a 72 Oldsmobile cutlass bumper bracket fit a 69 Oldsmobile cutlass?
Not likely why not just use the correct part?
How do you take off power steering pump on 2002 Oldsmobile intrigue?
To remove the power steering pump from a 2002 Oldsmobile Intrigue, first, disconnect the negative battery cable for safety. Next, remove the drive belt by loosening the tensioner, then disconnect the power steering hoses. Unbolt the pump from its mounting bracket and carefully lift it out of the engine bay. Finally, make sure to seal any open lines to prevent contamination before installing a new pump.
Where is the windshield wiper motor located on a 1991 jeep wrangler?
The wiper motor is mounted on the left inside of the windshield frame on the same bracket as the VIN. Fold down the windshield and is fully accessible.
2000 Oldsmobile Intrigue and after an ice storm your windshield wipers come to rest in the service position. pointed straignt up when you shut them off How can you get them to rest in their normal pos?
Same thing happened to me on 1998 intrigue. Also in snowy and freezing conditions. The link here attributed the problem to water freezing in the Wiper moter assembly Maybe it will start working when it thaws out? [hr] Wrong. Your windshield wiper motor is mounted to a bracket that has a little metal tab on it that the crank arm assembly has to hit in order to park the wipers, in a lot of cases this park tab in either bent or broken, and if bent can be adjusted. This happens if the wipers encounter too much stress, such as trying to wipe when they are frozen in ice. The tab can be easily bent back, if you can get to the wiper motor.
Location of battery on a 1996 grand prix?
It is under the windshield washer fluid reservoir and bracket.
Where is the starter on a 98 Oldsmobile Cutlass?
The starter on a 98 Oldsmobile Cutlass is located on the bottom, left side of the engine. It is held in place by a support bracket and bolts.
What can I use a tomtom bracket for?
A Tomtom bracket is a device that helps you keep your GPS in place. You can attach it to your car's windshield or dashboard. This video will guide you step by step. http://www.youtube.com/watch?v=iyLQ73c8zn8
How to disassemble a reclining sofa to move?
Usually, there are latches on both sides of the backs of the sofa. Then, you can pull the back straight up off the bracket that holds it in place.
