http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=98118
You need to buy an a/c spring lock coupler line disconnect set at any auto parts store and they come in a set of (4)..........
Most of them require ac line disconnect tools. The tools reach into the round part and release a spring.Most of them require ac line disconnect tools. The tools reach into the round part and release a spring.
To properly wire a disconnect for a residential air conditioning unit, follow these steps: Turn off the power to the unit at the main electrical panel. Install the disconnect box near the air conditioning unit, following local codes and manufacturer instructions. Connect the power supply wires to the line side of the disconnect box, following the color-coding (typically black for hot, white for neutral, and green or bare for ground). Connect the wires from the air conditioning unit to the load side of the disconnect box, matching the corresponding colors. Secure all connections with wire nuts and tighten all screws. Close the disconnect box and turn on the power at the main electrical panel. Test the air conditioning unit to ensure it is functioning properly. It is recommended to consult a licensed electrician if you are unsure about any step in the process.
The 2003 Chevrolet trailblazer air conditioning line can be found on the air conditioning compressor. The line goes from the compressor to the firewall. The line will go through the firewall to the air conditioner core.
Purchase a fuel line disconnect tool from the parts store, there are several types so get the right one. The fittings are spring loaded and need to be pushed in with the tool then pulled apart.
Spring line is the centerline of th epipe
The 1990 Mitsubishi does not have an air conditioning recharge line. The vehicle has an air conditioning recharge port. You can recharge your air conditioning system through the low pressure port on the air conditioning compressor.
It's possible there isn't a low side port. These systems are typically sealed and were charged at the factory. The couplings reseal when you disconnect them to preserve the refrigerant. You can probably add a port by installing a line tap. Make sure you get the right line though. My system has it on the larger of the two copper lines leaving the compressor.
bleed the fuelline of the fuel left in the line.remove the fuel line by unscrewing the couplings.replace the line and screw the couplings back.bleed the fuelline of as much air as possible.try to start your engine until it starts
Hardware that removes spikes and other anomalies from your line current.
Yes, there is air conditioning at the Jubilee Line Platforms from Westmister to North Greenwish.
You need a special tool called a fuel line disconnect to release the tabs.