answersLogoWhite

0

The best way is to use a coolant flush machine, as it takes fluid out, it puts back in the same amount. This way the system does not get air bound.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you change the radiator in a 96 lumina?

how do you change the radiator in 96 chevrolet lumina


What is the purpose of a radiator petcock?

To drain the radiator when it is time to change the coolant.


How do I change K1200GT coolant?

Begin by removing the bottom radiator hose. Allow the old coolant to drain out. Replace the hose to its original position. Fill the radiator with new coolant.


How do you change coolant on a 1993 Nissan 240sx?

open the radiator cap, find the plug at the bottom right of the radiator and open it to drain old coolant


How do you change the coolant in a 2004 gmc envoy?

The only way to drain all the coolant is to unhook the bottom radiator hose. The radiator does NOT have a drain vale.


How to change K1200GT coolant?

Remove the drain plug from the bottom of the radiator. Allow the coolant to completely drained out. Replace the drain plug to its original position. Fill the radiator with new coolant.


How do you change the coolant ina a Honda helix motor scooter?

To change the coolant in a Honda Helix motor scooter, first ensure the engine is cool and then locate the coolant reservoir and radiator. Open the radiator cap and drain the old coolant by removing the drain plug at the bottom of the radiator. Once drained, close the drain plug, refill the radiator with the appropriate type of coolant, and replace the radiator cap. Finally, run the engine for a few minutes to circulate the new coolant and check for leaks.


How do you change a thermostat on a 2005 Chevrolet Avalanche?

To change the thermostat on a 2005 Chevrolet Avalanche, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose and the thermostat housing, which is typically held by bolts. Replace the old thermostat with a new one, ensuring the gasket is in place, reassemble the housing and hose, refill the coolant, and finally reconnect the battery. Start the engine and check for any leaks.


How do you change the thermostat on a 2005 Chevrolet Impala?

Drain the radiator in a container. Remove the engine end of the top radiator hose. The housing has 2 bolts that you remove. Remove the thermostat and clean the surfaces and reinstall the thermostat. Reinstall the hose and add coolant.


How do you change coolant on a 2002 ford explorer?

Get something for the coolant to go into like a bucket. Remove the lower radiator hose from the radiator and also remove the radiator cap to help and drain into bucket.


How to do a coolant change on a Toyota Corolla?

To change coolant on a Toyota Corolla, place a bucket under the radiator. Open the radiator drain valve and remove the radiator cap. When all antifreeze drains out, close the drain valve. Then refill with fresh antifreeze and replace the radiator cap.


How do you change the low coolant sensor on a 1994 Bonneville?

It may be similar to my Chevrolet Impala Coolant sensor module is located under the upper radiator hoseLower coolant level below this point, remove old module-install new being careful not to damage "0" ring seal.