Rent, borrow or buy a code scanner from your local auto parts retailer, then connect it to the diagnostic port on your scanner. The port is located below the dashboard, next to the steering column.
If you have questions or in any way need assistance, the employees at OReilly or Auto Zone are usually willing to help, depending on the current amount of activity in their store.
error code cpk
Below and to the left of the steering column.
try autozone.com has online manuals that give step by step how to
Yes, you can obtain trouble codes for a 1995 Volvo 850 using the onboard diagnostic system. This model uses a diagnostic connector located under the dashboard, where you can connect a code reader or scanner. Alternatively, you can read the codes manually by using a jumper wire to connect specific pins in the diagnostic connector, which will cause the check engine light to blink a series of codes. Always refer to a service manual for the correct procedures and pin configurations.
1995 and later vehicles use the OBDII system and require the use of a scan tool to extract the trouble codes. Some auto parts stores will scan the system free of charge.
Codes on a 1995 Jeep are two digits long. So 5 means nothing.
1995 and later models use the OBDII and you need a scanner to retrieve the diagnostic codes. For pre-1995 models, you can check out a Haynes or Chilton manual at your local library for your year model. It will have specific instructions on diagnostic codes retrieval and a chart that tells you what each code means.
diagnostic connecter 1995 dodge truckThe diagnostic trouble codes on all models can be extracted from the Powertrain Control Module (PCM) using the (OBD-1) scan tool. The connector is along the wiring harness under the hood, on the firewall on the passenger side.
When there are problems with a vehicle it is important to find out what is causing them. To find the codes, one needs a code reader to do it on their own, or run it to an automotive shop.
Check out http://www.saturnspeed.com/diagnostic.php ------------------- plug is located above your left foot when sitting in the drivers seat
To find the diagnostic repair codes for a 1995 Buick Roadmaster, you can use an OBD-I scanner, as this vehicle is equipped with an On-Board Diagnostics system that predates OBD-II. Connect the scanner to the diagnostic port, which is typically located under the dashboard. Alternatively, you can perform a key-on, engine-off test by turning the ignition on and off several times to trigger the diagnostic lights on the dashboard, which will flash specific codes. For detailed code meanings and further diagnostics, refer to the vehicle's repair manual or an online database.
turn the ignition on but do not start the car. hold the Off and Red Warmer button on the Climate control panel to the right of your speedometer. hold them until the dash will flash off and on and it will then list you diagnostic codes