There is one screwed into each exhaust manifold.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
There is more than one O2 sensor on that vehicle and they are all threaded into the exhaust system at various points.
Bank 1 is the pass side.
the code P0132 on dodge intrepid is : the right upstream o2 sensor is shorted to ground , possible causes are the o2 sensor is gone bad , the wiring or connectors are damaged or corroded, or the ( PCM) power control module
To replace the O2 sensor in a 1999 Dodge Intrepid, first, ensure the vehicle is cool and disconnect the negative battery cable. Locate the O2 sensor, which is typically found in the exhaust system, either upstream (before the catalytic converter) or downstream (after the catalytic converter). Use an O2 sensor socket or a wrench to unscrew the old sensor, then install the new sensor by threading it in and tightening it securely. Finally, reconnect the battery and clear any diagnostic trouble codes if necessary.
O2 sensor circuit low voltage (bank 2 sensor 1)
With an o2 sensor socket.
Lambda is o2 sensor in exhaust pipe.
1995 vehicles did not have post cat o2 sensors.
P0304 is #4 cylinder misfire. P0131 is O2 Sensor Low Voltage Bank 1 sensor 2
It is your 2nd (Bank 2) O2 sensor.
The oxygen sensor is screwed into the exhaust manifold on the rear of the engine on a 1995 Chrysler Town and Country.