answersLogoWhite

0

rover metro door lockhi,, could you be more helpful,is it the doorlock or solenoid on the remote locking system,,does the key fob work .does the red light come on the dash ?
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Is there any 14 inch alloys of a rover that will fit on your rover metro?

It is possible that some 14-inch alloys from other Rover models may fit on a Rover Metro, but it is recommended to consult with a mechanic or check with a Rover specialist to ensure compatibility. Factors such as wheel offset, bolt pattern, and hub size need to be considered before swapping wheels to prevent any fitment issues.


Would 15 inch alloy wheels fit on to a 1995 N registration rover metro?

No They will not fit because the rear subfram is in the way.. 14" maximum on N reg rover 100/metro


Where is the fuse box for rover metro?

There are two fuse boxes located on the Rover Metro. One fuse box is located on the passenger side of the vehicle under the dash. The second fuse box is located under the hood.


What is the biggest rover engine that will fit in a rover metro?

biggest engine to fit is a 1.8 k series engine,no body modifications needed.


Why does the engine tap in a 1999 land rover discovery II?

you probably have a sticking valve lifter.


Where can one find information about the Rover Metro?

Information about the River Metro can be found online on the website Wikipedia. It can also be found in on the website for Metroparks that actually runs this service.


What is the spark plug gap on 1994 rover metro?

i need to check what the gap is but need to know the measurements x


How do drain the fuel tank on a Rover Metro?

Buy a syphon kit at hardware, auto parts or Wal-Mart


How do you fix a Rover Metro 111 gsi if the revs are staying high even after it is warm?

Make sure the throtle linkage isn't hanging.


What are the torque wrench settings for the cylinder head bolts and camshaft bolts for a Rover Metro 1100cc 93reg?

initially you tighten all bost to 28 newton metres then you angle tighten by 90 degrees leave for 5 mins and angle tighten by another 90 degrees this information was supplied to me by a trained rover mechanic i did it on my metro 1.1 on a j reg and it was fine


How much to get a head gasket fixed on a rover metro?

Pretty expensive (from a garage). Most people scrap their cars after a head gasket has blown, or get a new engine.


Where is the alternator located on a 1995 range rover?

It's attached to the engine. If you don't know what an alternator looks like, then you have no business even opening the hood. Leave mechanical things to a mechanic... especially on a Range Rover!

Trending Questions
How many gallons does a 2009 Chevy impala gas tank hold? How much does it cost to replace a starter in a Chrysler town and country? How do you bleed air off mark 8 AIR RIDE? Is the 2013 Cadillac CTS front wheel drive rear wheel drive or four wheel drive? How much freon to charge a 2014 ram cargo van? Where is the signal switch blinker located in a 1995 Chevy Corsica? Will passanger door from an 86 ford bronco fit on a 89 ford bronco? What would cause the brake pedal to become hard and only one wheel locks up I have replaced roters calipers shoes and the master cylinder? How do you replace the starter on a 2000 ford explorer? How do you replace the fuel pressure regulator on a 1998 38 firebird is it necessary to remove the fuel rail? What type of transmission is in a 1998 Dodge Ram 2500 with 5.9 diesel? How do you change water pump on 1990 Oldsmobile Cultass Ciera? Where does the windshield wiper fluid go on a Ford Fusion? What is the firing order for a 1990 Mazda van? SOMEONE....please help....all of the sudden my turn signals and hazards are not working on my 1998 crown victoria. it is definitely not a fuse problem...what is it? What is the meaning of fleur de lis? What is the Firing order ford 2.5 engine? How do you remove the front door panel on a 2001 GMC Sierra? What is the lowest octane gasoline your 2003 navigator will run on without causing damage to engine? What should you do if your kitchen drain is slow but does go down however it makes a kluging noise that lasts for several minutes after it does go down?