The first step is having the computer checked for codes. When you know the failure code you can diagnose for possible causes.
It stays on when the computer detects a malfunction in the electronic throttle system.
There is no such part. The computer uses inputs from numerous sensors to decide how to control idle speed with a airflow control valve on the throttle body.
The Chrysler Sebring cruise control switch is located beneath the dashboard, on the drivers side. The cruise control switch should be labeled as such.
To install an electronic throttle control in a 2006 Chrysler 300, first disconnect the negative battery terminal to ensure safety. Remove the air intake duct to access the throttle body, then disconnect the electrical connector and remove the mounting screws for the throttle body. Replace it with the new electronic throttle control, secure it with screws, reconnect the electrical connector, and reattach the air intake duct. Finally, reconnect the battery and perform a throttle relearn procedure if necessary.
You unbolt it
It is under the center console.
It is on because the engine computer has detected a malfunction with the electronic throttle control system.
It controls all functions of the transmission.
The dealer should.
Not used. It is driven by the PCM
It is the system that actuates the throttle plate electronically. This van does not use a throttle cable.
The engine computer controls the cruise.