itsprobably the resistor its located on the passenger side floor. You have to remove the cover under the glove box to access the fan the then trace the wires to the air box remove 2 bolts unplug the wires pull the resistor out . Its kind of tight but not bad. You should also test for power to the fan first...good luck
The heater fan or blower motor is located underneath the dash on the inside of the car located in front of the passenger seat.
The heater fan motor on a 1998 Buick Riviera is located inside the passenger compartment, specifically under the dashboard on the passenger side. To access it, you typically need to remove the lower dashboard panel. The motor is situated near the blower assembly, connected to the HVAC system. Make sure to disconnect the battery before attempting any repairs for safety.
How to fix heater in Buick there is cool air ,fan is work .but no warm air
In a 1996 Buick Riviera, the fan switch is typically located on the dashboard, integrated into the climate control system. It is usually a dial or a set of buttons that allow you to adjust the fan speed and airflow direction. If you're having trouble finding it, consult the owner's manual for specific details about your vehicle's layout.
I can't get the fan to work.
Yes, the 1989 Buick Riviera has a fan belt, which is commonly referred to as a serpentine belt. This belt drives various accessories in the engine, including the alternator, power steering pump, and water pump. Regular inspection and maintenance of the fan belt are essential to ensure proper engine function and prevent overheating.
In the 1998 Buick Riviera, the AC fan switch is typically located on the center console, integrated into the climate control panel. It features various settings for fan speed and temperature control. You can access it easily while seated in the driver's position, allowing for quick adjustments while driving.
To install a belt on a 1997 Buick Riviera, first ensure the engine is off and cool. Remove any necessary components for access, such as the engine cover or fan shroud. Then, route the new belt according to the belt routing diagram usually found on a sticker in the engine bay. Finally, check the tension and secure any components you removed before starting the engine to ensure proper operation.
were is the heater relay on1996 jimmy?
heater motor is gone
Please describe in detail what the a/c heater blower is doing I.E., air blowing out of one or both vents, defroster operating or not etc. jb
You don't change it. Ask your driver to get the car at a specialised service :)