answersLogoWhite

0

the led panel is burnt out you can either take it to a radio repair shop or buy a used radio you can't fix it

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where on the console is the select switch for 2x4 to 4x4 on 1998 ford explorer Eddie Bauer?

It's in the center stack of the dash , just to the left of the radio


Is there a switch to turn on and off the fog lamps on a 1999 Ford Explorer Eddie Bauer edition?

Yes , in the center stack of the dash , to the right of the radio


Where is the 4 wheel drive button on a explorer 96 Eddie Bauer?

The selector rotary knob is in the center stack of the dash , just to the left of the radio for the 4X4 Control Trac system


The lights of the radio wont turn on a 1999 Ford Expedition Eddie Bauer?

Check fuses , or bulbs in radio burn out.


You bought a after market radio and harness for a 91 Eddie Bauer explorer powers up but you get no sound why?

splice the blue amp wire on the harness to the power wire, your car came with a factory amp. that will give you sound.


Installed a radio but no sound?

you will need to bypass the amps in the passanger side rear of the vehicle if its the Eddie Bauer edition.


How do you set clock on 1999 EDDIE BAUER Ford Explorer?

To set the clock on a 1999 Eddie Bauer Ford Explorer, first turn the ignition to the "On" position without starting the engine. Press the "Clock" button on the radio or the dashboard, which will allow the hour display to blink. Use the "Tune" or "Seek" buttons to adjust the hour, then press the "Clock" button again to set the minutes, adjusting them in the same way. Once done, press the "Clock" button again to save the time.


Where can you find a radio wiring harness for a 1997 Eddie Bauer edition?

You can find a radio wiring harness for your 1997 Ford at most auto-parts stores. Many electronic stores will also have the radio wiring harness.


How do you remove radio from 1999 ford expedtion Eddie Bauer?

To remove the radio from a 1999 Ford Expedition Eddie Bauer, first disconnect the negative battery cable to ensure safety. Use a flat-head screwdriver or a trim removal tool to gently pry off the surrounding bezel or trim panel around the radio. Once the bezel is removed, unscrew the mounting screws holding the radio in place, then carefully pull the radio out and disconnect the wiring harness and antenna cable from the back. Reinstall in reverse order when finished.


Radio won't turn off after engine is shut off on 2000 Ford Explorer Eddie Bauer edition?

The radio is usually supplied power until you open one of the doors. Perhaps what you have is a bad door sensor? Try shutting off the car, and then opening the passenger door and see if it shuts the radio off. If that doesn't fix it, then whatever module the radio is connected to is probably bad.


What number on the fuse case is for the radio for the 2003 ford expedition Eddie Bauer?

Check your owners manual. If you don't have one copy & paste this link. http://www.genuineservice.com/genuineservice/en/gloveboxresults


What number on the fuse case is for the radio and clock for the 2000 Eddie Bauer expedition?

Check your owners manual. If you don't have one copy & paste this link. http://www.genuineservice.com/genuineservice/en/gloveboxresults