The factory service manual says that to get the spark plug wire off of the spark plug: Twist the boot about a half turn to loosen it from the spark plug and then pull it off using the boot.
Don't pull the spark plug wire to remove it as you may find yourself pulling the wire out of the connector. Pulling it off by the boot may also leave the connector on the spark plug.
To change the spark plugs on a Vauxhall Zafira open the hood of the vehicle. The spark plugs will be located on the engine. It is best to used a spark plug removed to unscrew the plugs. They will be connected to a cable. Remove the cable. Replace the plugs with new ones and reattach the cable.
Disconnect the battery, remove the spark plug covers and cable, and remove the old spark plugs. Put in the new spark plugs, replace the covers and cable, and reconnect the battery.
2003 c320. So a v-6 correct? They are located on both sides of the engine. Your engine will have spark plug cable wires going from the ignition coils to the spark plugs, you need to remove the cables off the plugs before you can remove the spark plugs.
Disconnect the battery, remove the spark plug cable and covers, and remove the old spark plugs. Put in the new plugs, put back the covers and cables, and reconnect the battery.
Pull on the boot.
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
Disconnect the car battery cable, remove the spark plug cables, remove the spark plug boots, and remove the old spark plugs. Next, put in the new spark plugs, replace the boots and cables and reconnect the battery cables.
The spark plugs are on the front and back of a V6 (back ones are tough to get to) L4 right in front. Turn the engine off and take off the spark wires unscrew the plugs
How to replace spark plugs on a 2010 ford fusion
Just locate the distributor and follow any cable to the other end (except the one in the center) and that's the spark plugs
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
The spark plugs are screwed into the head on the passenger side of the motor. Theres six sparkplug cables connecting them to the distributor, just pull them off and the plugs are there in the recesses. Don't forget wich cable goes to wich plug because your car will not run if they aren't in the correct place.