The speakers are under the grills near the outer edge of the dash cover.
To get the speaker grills out simply pry up on them with a thin blade screw driver. Be careful to avoid deforming the dash cover. The speakers are held in with screws, take them out and pull up on the speaker, release and remove the wire connectors.
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
All Chevrolet Celebrity cars are FWD (front wheel drive).
To change the front blinker bulb on your 1989 Chevy Celebrity simply reach up behind the bumper and unplug the socket from the fixture. Replace the bulb in the socket and plug the socket back into the fixture.
On a 2.8l v6 it is at the front of the engine behind the ignition coils.
The petcock on a 1989 Chevy Celebrity is at the bottom of the radiator on the drivers side.
For the front speakers you need to take off the dash pad and the rear speakers you need to take off the rear speaker panels.
The oxygen sensor on a 1989 Chevy Celebrity is located in the rear exhaust manifold on top about the center.
Looking in my factory service manual for a 1989 Chevy Celebrity I found no reference to an accessory relay.
The spark plug gap for your 1989 Chevy Celebrity 2.8 V6 is .045".
The 1989 Chevy Celebrity V6 is rated at 130 hp.
The stock speakers in a 1989 Chevy pickup typically measure 4x6 inches for the front door speakers. The rear speakers, if equipped, are usually 6x9 inches. However, configurations can vary based on the specific model and any aftermarket modifications. Always check your vehicle's manual or inspect the installation for accurate sizing.
The front speakers in a 1989 Mazda B2600 truck measure 5 inches by 7 inches. These speakers are located in the front doors.