First you are going to need the following before you attempt to try the job. I just did this on my 01 sierra it isn't that bad. You are going to need the 03 bumper, 03 bumper cover, 03 bumper brackets they are all completely different, and the 03 grille( the 01 grille will fit but will look very goofy). you are going to leave the factory brackets on the frame. Then put the main center brackets on the bumper its self and line up the brackets with the frame and mark spots where you are going to drill holes. Then hook bumper cover to bumper and hook it all up. What i did was go to a car lot that had a 03-06 sierra and took pictures of how the brackets were faced and what length bolts you are going to need to buy. Have fun!!!
how do i change the front bumper on my 1999 vauxhall vetra
only if the bumper from the 250 is a non-superduty
To install a front bumper cover on a 2000 Subaru Outback, first, ensure the vehicle is parked on a flat surface and turn off the ignition. Remove any screws, clips, or bolts securing the old bumper cover, and gently pull it away from the vehicle. Align the new bumper cover with the mounting points, then secure it using the original screws or clips. Finally, check that all fasteners are tightened and the cover is properly aligned before finishing.
no such car
Sledgehammer.
Maybe
Yes
how do you install front fog lens on a 2000 buick regal
The front bumper of a 2000 Honda Civic is held on by several mounting screws. First remove all the screws, then gently pull the bumper off the remaining mounting clips.
All civic front bumpers from 1999-2000 are interchangeable, however the rear bumper of the Hatchback model differs from the rear bumper of the coupe and sedan.
The horn is located behind the front bumper fascia
The horn is located behind the front bumper fascia