After you removed the interior door trim, you will need to drill the rivets that hold the motor in place. Or else, you can do the job with a hammer and chisel if you wish to. After this is accomplished, you just need four 1/4 inch bolts (1 inch long is OK), four flat washers and four self locking nuts(the one with the nylon sleeve in it). You mount the motor placing the bolts from the inside (making sure the bolt heads won't interfere with the travel of the window crank), and finishing with the washers and nut from the outside. Now you have a new motor that can be dismounted much faster if the you ever need it again.
Stick the starter in the cutlass supreme.
cutlass supremes are so baller
lever along side drivers seat.
Use a 10mm socket.
Look on the drivers side door at the specs decal for that information.
A Hanes or chilton manual
front drivers side of motor you can follow your lines back from the condensor
In the fuse box under the dash on drivers side.
Open the glove box, which should be opened by turning the round lock. Then, take everything out of the glove box. Now, pull the "Box" itself out. The fuses are located here.ANSWEROn my 95 cutlass supreme, the fuse box is on the side of the dash, right inside the passenger side door. You have to remove a panel that says "fuses" on it.
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
Oldsmobile Cutlass Supreme was created in 1966.
mine is under the hood in the fuse box on the drivers side