all you should have to do is take the distributor cap off, and there it is.
answer
take the distributor cap off, pull the old rotor off, put the new one on, put the cap back on.
Absolutely
I DON'T KNOW!
The first step is to turn off the engine. When installing, lift the cap to reveal the direction the metal tab is pointing on the rotor. Then remove the rotor for new installation.
1-8-4-3-6-5-7-2 Rotor turns clockwise.
Will a 2005 chevy silverado cap fit a 2008 chevy
Cap and rotor, yes. Points, no.
To change the distributor cap and rotor on a 1997 Chevy pickup, first, disconnect the negative battery terminal for safety. Remove the screws or clips holding the distributor cap in place and carefully lift it off, noting the wire connections for reassembly. Next, take out the rotor from the top of the distributor by unscrewing or lifting it off, then replace it with the new rotor. Finally, install the new distributor cap, reconnect the wires as they were, and reattach the battery terminal.
Bad distributor cap, and possible coil and coil wire. I would replace cap and rotor with new one from the Chevy dealer ONLY. FIRST Already did that. Any other options?
Plugs, cap and rotor, air filter, fuel filter, PCV valve. Plug wires if yours are bad.
Check all vacuum lines
Rotor Under Cap Spins: Clockwise
yes ther is.