ask the parts store if they have an adapter with a female end on 1 side & a male end on the other end. yes they make it i just picked one up.....
Yes you can, although there are some manual modifications to the wiring harness. The analog connector is 18 pin, and the digital connector is 34 pin. You can read a how-to guide here: http://people.oregonstate.edu/~akeym/
Remove the wiring connector from the back of your headlight assembly. Take hold of the light bulb, push in and turn at the same time to remove. Reverse the process to install the new light bulb.
, If you are referring to installing a connector that you can use for a trailer hookup there should be a connector already installed a taped up under the van, near the left rear wheelhouse. There should be about 6 wires that are also taped up and are "blunt cut", coming from that connector. You will need a schematic of wiring diagram and a trailer connector (with wires) to know how to splice the wires in. Take Care, Greg
www.chiltondiy.com and purchase for $19.95 the entire manual, with access for one year.
Chevy did not use a reset / INERTIA switch on there trucks. Chevy did have a problem with the wiring harness at the top of the fuel tank / connector. You may also want to check the fuel pump relay and fuse.
NO you can not, won't work, engine won't run.
Remove wiring harnesses, unbolt it, remove from engine. Install new alternator, apply tension using bar, bolt it, hookup wiring harnesses.
Begin by removing the wiring harness from your 1996 Chevy Corvette horn. Remove the horn retaining bolts. Reverse the process to install the new horn.
Wiring scamatics 65 Chevy dash
well is it a radio wire harness because if so yes
my 2008 express with the 6.0 heats up to 260 degrees when towing a 6000lb trailor
You can get a 2001 Chevy Express wiring diagram at your local library. Most libraries will have the Chevy service manual with the wiring diagram.