depending on your alternator, it will be on the back held on by 2 Phillips screws. it will either be in plain sight or under a black plastic cover. remover the two wires, and remove the small screws on back of cover. there are 3 plastic snap-locks on outside of cover. gently pull them to un snap the cover and slide cover off. volt reg is round black item about the size of a quarter held on by the aformentioned screws. its as easy as unscrewing and pulling off. install new one is two screws. it wil take you longer to jack the car up then to do this job. VERY easy for a d.i.y..
The engine computer is the voltage regulator.
where is voltage regulator on 1990 lincoln town car
The engine computer is also the voltage regulator.
The engine computer is also the voltage regulator.
Voltage regulator is located inside of the alternator.
The PCM (engine computer) is also the voltage regulator.
The voltage regulator is inside the alternator.
The engine computer is the voltage regulator.
To install a new wiring harness for the voltage regulator on a 1990 Mercury Topaz, first, disconnect the battery to ensure safety. Remove the old harness by detaching the connectors from the voltage regulator and any securing clips. Connect the new wiring harness to the voltage regulator, ensuring all connections are secure and properly aligned. Finally, reconnect the battery and test the system to ensure the voltage regulator is functioning correctly.
Why would you want to bypass the computer? In any case the answer is no, you cannot by-pass the computer.
Built into the alternator.
A bad voltage regulator can cause an overcharging condition. Check the wires going to the regulator for corrosion and make sure the regulator has a good ground.