answersLogoWhite

0

remove steering column and check this link. the buzzer is the red box on back of instrument panel.

http://www.oldspower.com/vb/showthread.php?t=47536&highlight=chime+module

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you remove Headlight assembly on 95 Olds Cutlass Ciera?

The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.


1980 olds headlight warning buzzer location?

Under the dash on the left hand side..


What is a 1998 olds cutlass what is its value?

what is a 1998 olds moblie cutlass value


Where is ecm located on 1987 olds cutlass?

where is the emc located on a 1988 olds cutlass?


How do you drain s 1999 Olds Cutlass radiator?

how do you drain s 1999 olds cutlass radiatoe


Where is the water pump on a 1995 olds cutlass supreme?

Where is the water pump on a 1995 olds cutlass supreme?"


Where is the computer on a olds 1991 cutlass supreme v6 3.1 engine?

Look in the engine compartment on passenger side below fuse box near the front headlight.


Where is the headlight adjustment screws on a 1997 Olds Cutlass Supreme?

take it in to the dealer and have them adjusted as they have a gauge they put on the lights to get them set perfect, if there not set right you will end up blinding someone coming at you or you will be way off on the headlight aim.


Can you switch one ecm with another out of the same type car 1993 olds cutlass supreme?

i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?


How do you replace a starter on a 1998 olds cutlass?

how do you replace a starter on a 1998 cutlass


Do a 1997 cutlass have a fusible link?

do a 1997 cutlass olds. have fusible link


How do you change headlight on 1996 olds cutlass supreme?

They should be halogen. Reach behind the headlight housing and find the suspect bulb. Remove the wire...you may need to gently pry with a screwdriver. The bulb twists into a socket. Untwist it and it should slide right out. Whe you re-install the new bulb, do not touch the glass. Oil and dirt from you fingers will etch the glass and cause it to fail.