You need to buy a Haynes Repair manual.
To replace the knock sensor, you need to remove the antifreeze from the engine.
You need to disconnect the battery.
You need to remove the alternator and the air box. ( You actually dont need to remove the alternator seeing as I did it with out taking the alternator off)
You need to remove the fuel injection and the air intake manifold.
Under the manifold there is a inspection plate that has two wires going into it.
You will need to replace both sensors and both wiring harnesses that goes to the sensors.
You will need a new intake manifold gasket and a torque wrench that is in INCH POUNDS - not foot pounds to torque the intake manifold.
You will need to permetex the valley around the knock sensors to divert the water away from the knock sensors.
Connect all the wires to the proper terminals and replace the anti freeze if it is more then 3 years old with a Universal antifreeze.
Reconnect the battery wire and you should be good to go.
you mean knock sensor
You can run a diagnostic test for the knock sensor, on your 2005 Chevy avalanche, by hooking the engine up to a diagnostic tester.
There are two knock sensors, they are both located under the upper intake manifold.
That engine has 2 of them and you MUST remove the intake manifold to service the knock sensors.
2003 chevy tahoe knock sensor
Where do you find a knock sensor on 1999 Chevy lumina
The 1500 Chevy Silverado has two knock sensors. There is one on each side of the block halfway between front and back.
under the intake. in the valley. 2 knock sensors actuallly
how do you change the knock sensor in a 2003 Chevy silverado 5.3
what will happen if you install a knock sensor that isn't called for that make & madel
That year vehicle has a carburetor and does not use a knock sensor.
how to replace a knock sensor on a 2000 Chevy 6.0 step by step