0
The engine code in the VIN will be a U for the 8-valve engine and a 6 for the 16-valve engine. My footnote for these also says the 1995 16-valve engine iis a California and New York model. The engine type digit is the sixth digit?letter in the VIN. Hope this helps.
What else can I help you with?
How do you open engine compartment on 1995 tracker?
I believe the release is in the glove box.
1995 Geo Tracker check engine light codes?
www.troublecodes.net Good luck I have a 1995 jdauksz1@charter.net
What engine is in a 1995 Geo Tracker?
16 valve 1.6 liter 4 cylinder.
Will a 1993 Tracker engine interchange with a 1995 tracker?
yes, if 8v for 8v or 16valves to 16v if not , huge list . see my swaps page, in my profile.
How do you know which engine your 1994 tracker has?
8 digit of the vin num
Where is the thermal flasher located in a 1995 Geo Tracker?
I don't know what a thermal flasher is.
I have 1995 4x4 Geo Tracker with a bad auto transmission will auto transmission out of 1998 4x4 Geo Tracker fit in 1995 Geo Tracker?
i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995
Where is the starter located 1995 Geo Tracker?
on the passenger side of the engine. you can see it from the top and it has a rubber boot on the forward end.
Is the tracker 2.0L engine a suzuki engine?
Can a 2001 Suzuki Vitara 2.0 Engine be swapped with a 2001 Chevy Tracker engine?
Can you put a 1995 Geo Tracker engine into a 1997 Geo Tracker?
if they are both 16 -valve engines ,yes if one is 8-valve & the other is 16-valve, then short block only ANSWER: The '95 and '97 Trackers have different sensors and ECU's. The only way you could put a '95 engine in an '97 TRacker would be if you also had the ECU from the '95
Will a fivespeed trans out of a 1990 Geo Tracker fit a 1995 Geo Tracker?
Yes it should.
What is the distributor cap firing order for 95 Geo Tracker?
The firing order for a 1995 Geo Tracker, which has a 1.6L engine, is 1-3-4-2. The distributor cap terminals are arranged in this order, with cylinder 1 typically located at the front of the engine. Ensure that the ignition timing is set correctly for optimal engine performance.
