There's a hood release on the drivers side near the floor by the door. There's a latch under the hood in the middle.
Open the hood. Filter is on the lower right front
The hood release for a 2012 Jeep Liberty is located on the driver's side, near the left footwell. It is a lever that you pull to unlock the hood. After pulling the lever, you may need to lift the hood slightly and find the safety latch underneath to fully open it.
The horn relay fuse for a 2004 Jeep Liberty is located in the fuse box under the hood. To find it, open the hood and look for the fuse box near the battery. The horn relay is typically labeled on the cover of the fuse box, so check the diagram for the specific location. If you're having trouble, consult the owner’s manual for more detailed instructions.
The hood release lever is located below the instrument panel in front of the driver's side door. Raise the hood, and use the latch to hold the hood up.
The hood latch on a 2003 Jeep Liberty is located at the front center of the vehicle, underneath the hood. To access it, you typically pull the hood release lever inside the cabin, usually found on the driver's side near the footwell. Once the hood is slightly raised, you can find the secondary latch under the hood, which you need to lift to fully open the hood.
To replace the driver side headlight on a 2004 Jeep Liberty, first, open the hood and locate the headlight assembly. Disconnect the power connector from the back of the headlight by pressing the tab and pulling it off. Remove the retaining clip or screws that hold the headlight in place, then pull the headlight assembly out. Insert the new headlight, secure it with the clip or screws, and reconnect the power connector before closing the hood.
I really don't think there is a hood open warning.
Depends what year you have. Mine's an 02. In mine, the hood release is on the driver's side near the floor at the base of the door frame. After you pull that latch you have to release another latch which is actually under the hood itself. On my 02 the second latch is right under the front of the hood just about where the J is on the JEEP logo on the hood.
Hood prop
To keep the hood of a 2002 Jeep Liberty open, locate the hood release lever inside the vehicle, typically found near the driver's side door. Pull the lever to release the hood latch, then go to the front of the vehicle and lift the hood. Once raised, secure it with the prop rod that should be located on the underside of the hood. Make sure the rod is fully engaged in its designated slot to prevent the hood from falling.
open the back gate on the liberty and there will be nuts there- remove with nut driver or socket and carefully swing out lens- will be sticky so be careful!
Trouble code P0800 means: Transfer case control system MIL request - circuit open