How do you program a key fob on a 1998 corvette?

Answer 1

Hold down the lock and unlock buttons together for 5 seconds or until you hear the horn/hear the locks. I have a new fob (correct part number) but it does not set with the above instructions.
Does the ignition key have to be in, should the auto lock on the fob be in the on position?

If that did not work you may need to match your transmitters by doing the following:

To match transmitters to your vehicle:

1. Turn the ignition key to ON.

2. Clear any warning messages on the Driver

Information Center (DIC) by pressing the

RESET button.

3. Press the OPTIONS button on the DIC several times

until the blank page is displayed, then press and hold

the RESET button for two seconds.

4. When the message FOB TRAINING is displayed,

push the RESET button once. The message

HOLD LK + UNLK 1ST FOB in the DIC will

be displayed.

5. Press and hold the LOCK and UNLOCK buttons on

the transmitter simultaneously for 15 seconds.

6. When a transmitter is learned (matched), the DIC

will display FOB LEARNED and then prompt you

to learn the next transmitter.

7. Repeat Steps 5 and 6 for each additional transmitter.

8. Remove the key from the ignition.

The programming mode will shut off if:

You don't program any transmitters for two minutes.

You take the key out of the ignition.

You have programmed three transmitters.