If this a new fob that has never been programmed before you will need to go to the dealership to have it done. If it's one that quit working & you've had to replace the battery in , stand next to the car and depress the lock & unlock buttons at the same time,it may take 15-20 seconds for this to work,but when it does the headlights will flash on then off.
Because Monte Carlo is a Biscuit and it would be rather stale if its from 1994... fool!!!
In most cases if you call your local Chevrolet dealer, give the parts dept. your VIN (Vehicle Identification Number) you can order a key fob for that car.
go to programyourremote.com and it will tell you how to do it for free.
The problem with the Monte Carlo is in the Security system itself I own a 2001 SS and it use to do the same thing. The security system does not recognize the key, when you use the key pad to enter the car. The only way I got it to work correctly was to Stop using my key FOB (remote). If you have the problem where your vehicle will not start, Get out, put the key in the door with it closed and turn the key to unlock for 10 seconds. It tells the car that the key was used to open the door not the key FOB. Monte Lover.
Let the Kia dealer do this ... the car is still under warranty.
How do you program a key fob to a 2003 Chevy Malibu
To program any kind of key fob you have to take it to a dealership.
How do I re program my key fob for renault laguna estate 1997?
change battery in a 2007 toyota avalion key fob
When my 2003 Monte did that it was a bad connection to the battery. It got just enough power to think it was being stolen and my key fob stopped working. Once I cleaned up the battery contacts it was fine.
To program a replacement key fob for a 2007 Mini Cooper S with Comfort Access, start by entering the vehicle with an existing, functional key fob. Insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the "lock" button on the new key fob for about 10 seconds, then release it and turn the ignition off. Finally, test the new key fob to ensure it locks and unlocks the doors. If this method does not work, consult the owner's manual or a professional for assistance.
To program a 2007 Ford Sport Trac key fob, first, enter the vehicle and close all doors. Next, insert the key into the ignition and turn it from "Off" to "Run" eight times within ten seconds, ending in the "Run" position. The locks should cycle to indicate successful entry into programming mode. Finally, press any button on the new key fob to program it, and the locks will cycle again to confirm successful programming.