0
Undo the wiring harnesses - remove the screws holding the lower dash from the upper dash (3 sections: one from the driver door to the center console, one where the center console is, and one from the center console to the passenger door) - remove the 2 screws holding the top of the instrument cluster (there are 2 1/2" holes on the underside of the gauge cluster top) - look up under the dash and you will see clips holding the vinyl dash pad to the metal cowl panel (there are space for about 5-6 clips although mine only had 3 used) - You have to pull down on the clips gently (at least I did) and then pull the dash away from the metal cowl.
What else can I help you with?
Why is there water dripping in the floor board of your 98 Chevy Camaro?
your heater core is going bad
How can I properly finish a butcher block cutting board to ensure its longevity and durability?
To properly finish a butcher block cutting board for longevity and durability, follow these steps: Sand the board to remove any rough spots or imperfections. Apply a food-safe mineral oil or beeswax finish to seal and protect the wood. Allow the finish to fully dry before using the cutting board. Reapply the finish regularly to maintain the board's quality and prevent drying out or cracking.
How can I properly maintain and care for my cutting board with beeswax?
To properly maintain and care for your cutting board with beeswax, first clean the board with mild soap and water, then dry it thoroughly. Apply a thin layer of melted beeswax to the board, using a clean cloth or brush. Let it sit for a few hours or overnight to allow the wax to penetrate the wood. Buff the board with a clean cloth to remove any excess wax. Repeat this process every few months to keep your cutting board in good condition.
How can I properly maintain and protect my cutting board using beeswax?
To properly maintain and protect your cutting board using beeswax, first ensure the board is clean and dry. Then, apply a thin layer of melted beeswax to the board's surface, using a clean cloth or brush. Allow the beeswax to penetrate the wood for a few hours or overnight. Finally, buff the cutting board with a clean cloth to remove any excess wax and restore its shine. Repeat this process every few months to keep your cutting board in good condition.
How do you fix sagging laminated floor?
You have to remove it and properly repair the underfloor or main flooring. Many cases of this appear in mobile homes where the underfloor is made of K3 or chip-board. Remove this and replace with plywood before replacing the laminate.
Where is headlamp relay on 1997 z28 Camaro?
go to, http://www.camaroz28.com/ , they have a good message board
Where are fuses located on a 1989 camaro?
Right above the drivers side floor board under the dash.
How can you remove the dash board on a dodge avenger?
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
What are the steps to remove a 2003 Mitsubishi Eclipse dash board?
Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.
Is OSB board waterproof?
OSB board is not waterproof, but it can withstand some moisture if properly sealed or treated.
How can I properly flash a ledger board for a deck installation?
To properly flash a ledger board for a deck installation, you should first ensure the ledger board is securely attached to the house. Next, install flashing over the top of the ledger board to prevent water from seeping behind it. Use a continuous piece of flashing that extends past the edge of the ledger board and is properly sealed to the house. This will help protect the ledger board and the structure of your home from water damage.
Can you board an airpalne with a cheesecake?
If it is properly wrapped and all, yes.
