answersLogoWhite

0

I use a "C" clamp to push them back in. Most shadetree mechanics do it this way. It works! For lack of a "C" clamp, a big pair of channel lock pliers will also work.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Brakes for I30 Infinite?

How do you put rear brakes and pistons back on a 2001 Infinity I30


Why does the ABS come on every time the brakes are applied on a 2001 mercury cougar?

The brake system was not that secure


Do you have to bleed the rear brakes of a 2001 Volvo S60 after replacing brake pads If so where is the bleeder and how do you do it?

There should be no need to bleed the brakes after replacing the rear (or front) brake pads. Make sure you place a rag around the top of the fluid reservoir to catch any excess as you press the pistons back into the caliper body though. If the brake pedal has gone spongy after pad replacement this suggests that the piston seals have failed or the caliper cylinder facess have corroded. On mine the bleed nipples are on the caliper body.


Why do rear brakes lock up 2001 Chevy Tracker?

Frozen caliper? if disc brakes Broken or disconnect return spring if drum brakes? Brakes not adjusted properly? Parking brake cable frozen and not releasing?


What is the torque spec for brakes on a 2001 highlander?

The torque specs on a 2001 Highlander areÊfor the caliper bolts and the brake line union boltÊon the brakes. The torque specs are, 32 ft. lbs. and 21 ft. lbs.Ê


Why would brakes lock up on 2001 Triton ute?

Front caliper piston seals are gone can get kit for 35 bucks


How do you replace the front brake pad wear sensor wire on a 1999 Mercury Cougar 25L?

http://www.carquest.com/techbulletins/brakes/2001/CQB%2001-10.pdf


The dust boot seal on the rear caliper is broken on my 2001 Passat. What can happen if I don't replace it Can it be replaced How difficult it is?

The brake caliper boot seal keeps out dust and dirt. If not replaced it can cause the caliper seal to leak and the brakes to possibly fail. It is simple to replace.


What size wrench is needed to remove the caliper bolts on the front brakes of a 2001 Chevy Suburban?

It takes a T55 Torx bit on the front calipers.


How do you push back the caliper on the rear brakes on a golf 2001?

There is a special tool that one needs to accomplish this task. It turns the piston while pressing the same piston into the caliper body. Try www.germanautoparts.com to purchase same. Do not try to do it without this tool, you will damage the caliper and it will cost you $$$$$ to replace.


How do you replace front disc brakes on a 2001 dodge neon?

Remove wheels Re-install 2 lug nuts to hold rotor in place Loosen both caliper mounting bolts Remove 1 to swing caliper off rotor Retract piston fully into caliper body using a "C" clamp Remove old pads Install new pads Re-install caliper on to rotor PUMP BRAKES TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE


Where is the radiator located on a 2001 Mercury Cougar?

On a 2001 Mercury Cougar : The radiator is located in the engine compartment , at the front of the vehicle