0
What else can I help you with?
Does the 1985 corvette l-98 engine have forged pistons and steel crank?
yes it dose have ( trw ) one eye brow forged pistons !!!! cant remember about the crank... Yes it is a steel crank.
Clearance issues with Chevy 350 pistons hitting the crank?
If the pistons are hitting the crankshaft, either you have1. the wrong pistons (350 pistons are relatively short butit is possible to purchase pistons with the same bore but a longer skirt... in which case they would hit the crank)or2. the wrong crankshaft with too much "throw"
Can you replace crankmainsand rod bearings without pulling off heads and removing pistons from bores?
No. Crank and main bearings can be get at by dropping the oil pan, but to get to the small end rod bearings you've got to get the pistons out.
Is the crank shaft pulley supposed to turn freely?
No, it's bolted to the end of the crank which pistons/rods attached to.
How do you build a 383 Chevrolet motor?
you put in a 400 crank and shorter pistons
What is meant by crank case ventillation?
as the pistons go up and down, and the temperature changes the air in a crank case has to go somewhere. that is what the vent is for
How much does a cast iron 350 block weigh without the crank cam or pistons?
you need a casting number some have thicker walls 2bolt vrs 4bolt mains ect.
What if the crank to cam timing gears are off?
The engine will not run, possibly damaging valves and pistons.
What is function of crank in piston engine?
it turns the pistons causing the combustion neceserie to run the vehical
Can you change your crank shaft in your 99 dodge 1500 5.9 magnum without pulling the engine?
No.
Do the pistons turn the crankshaft or the crankshaft turn the pistons?
Technically both, before the vehicle is running on its own via combustion the crankshaft rotates and moves the pistons, once combustion has occurred the pistons take over if you will and turn the crank which rotates the next piston into position for combustion
What is the stroke if you put a 327 crankshaft in a 350 Chevrolet?
Putting a 327 crank in a 350 makes it a 327. (3.25") You can't put a 327 crank into a 350 without changing the pistons. The piston would be 1/4" down in the hole, and would have very little compression.
