0
You must remove the drive shaft. But first block the wheels so truck don't roll.
Now take a screew driver a hammer and drive the seal out, you will loose some fluid but not much. If your good you can drive the new seal in with a hammer. If not they do make a seal driver that a parts store might rent you.
If you still have a leak and your sure its coming from the seal and not the yoke on the drive shaft. Then the bushing in the trans. behind the seal needs replaced, and that can be trickey. Don't forget to polish the yoke on the drive shaft were it slides into the trans. GOOD LUCK
What else can I help you with?
What is the length of a nv3500 transmission from the front of bellhousing to the rear seal in a 1991 Chevy 1500 2wd?
The length of the 1991 Chevy 1500 transmission is 37 inches. The bell housing will account for approximately 5.5 inches.
How do you change rear seal in 1990 1500 Chevy truck?
That is a 1 piece seal. You will either have to pull the transmission out are the engine what ever you think is the easiest for you.The seal just drives in a housing over the back of the crankshaft.
Do you have to remove transmission to replace the rear main oil seal in a 2000 Chevy cavalier?
You must remove the transmission are engine to replace the rear main seal.
How do you change the rear main seal on a 2001 Chevy Tahoe 4WD SUV?
The engine rear main seal can only be replaced with the engine or transmission out of the vehicle.
How do I replace the Rear main engine seal on a small block Chevy?
You will need to remove the transmission.
What is the rear main seal in a 1988 Chevy Camaro?
rear main seal is the gasket around the crank between the rear of the motor and the transmission. front and rear main seals are usual spots for oil leaks.
How do you change the rear main seal on a 2000 Chevy blazer?
you have to pull the transmission out-- or the enging which either is easier
How much does it cost to replace a rear main seal on a 2002 Chevy silverado 1500 v8 5.3 liter engine?
$500.00
How do you determine if the rear main seal is damaged leaking on an 2002 Chevy Tahoe?
You will have to pull the transmission out and remove the fly-wheel to inspect the rear main seal. It is a 1 piece round seal that slides over the rear of the crankshaft. If the rear main seal is leaking on that 2002, I would find that very odd.
How do you change rear main seal on Dodge Ram 1500 5.9?
To change the rear main seal on a Dodge Ram 1500 with a 5.9-liter engine, first, disconnect the battery and remove the transmission by unbolting it from the engine. After that, drain the engine oil and remove the oil pan to access the rear main seal. Carefully pry out the old seal, clean the sealing surface, and install the new seal using a seal installer or a similar tool to ensure it sits evenly. Finally, reassemble the oil pan and transmission, refill with oil, and reconnect the battery.
How do you chenge a rear main seal in a 97 Toyota Camry 4 cylinder?
remove transmission, remove rear main seal, install new rear main seal, install transmission.
Why does oil leak from the seal of a manual transmission on a 1995 Chevy s-10 truck?
Assuming we are talking about the rear oil seal on that transmission, if it has been replaced and it still leaks, check the condition of the universal joints in the driveshaft.
