0
What else can I help you with?
How do you replace the water pump on a 1999 Ford Escort?
support the engine on a floor jack, remove the motor mount on the right side, clear access to and remove the timing cover, remove the timing belt. Water pump is under the timing belt. Replace the water pump and reassemble. It is strongly reccommended that you install a new timing belt.
Does the timing belt on a Chrysler Sebring V6 2.5L run the water pump?
yes it does... you have to jack up the motor and remove the passenger side motor mount bolts and bracket bolted to the front of the engine block. as well as the crank shaft pulley and the center belt cover/plastic shrouding) to access and remove the water pump... the pump runs off the timing belt directly, the backside of the belt itself.
Where is the water pump located on a 1990 Geo Prism?
The water pump is on the right side, with the belt from the alternator, and a separate belt from the power steering pump attached to its pulley. Cant remove it withought lifting the motor, and removing the timing belt cover though
How do you change drive belts on 1967 Cadillac deville?
CHANGING ALTENATOR BELT: 1. loosen compressor bolts push towards engine to remove compressor belt 2. loosen power steering bolts and push pump towards engine to get slack to remove belt. 3. loosen altenator bolts pus it towards motor to get slack and remove belt. 4. put new belt on push altenator away from motor to tighten slack in belt and tighten bolts 5. push power steering pump away from motor to tighten belt and tighten bolts 6. push compressor away from motor to tighten belt and tighten bolts. REMOVE FAN BELT: Do steps 1,2,5 and 6 REMOVE COMPRESSOR BELT: Do steps 1and 6
How do you remove power steering pump from a 1995 Lumina APV?
remove motor mount from right side of motor ,remove belt ;use 13mm socket to go in pulley holes of pump; should be three bolts at 2 o'clock 4o'clock and 7o'clock positions
Water pump location on a 1997 Chrysler sebring convertible?
at the "front" of the motor behind the timing belt. you have to remove the timing belt covers and, remove the timing belt, and the water pump is one of the the center pulleys i have been told by many mechanics that you have to remove the intake manifold to change the pump because one of the supply pipes are underneath it and you cannot get to them without removing it.
Where is the vacuum pump in a 2004 E350 Ford van?
It is on the drivers side of the motor connected to the fan belt. You have to lift the motor approx 2 inches to remove it
Where is the water pump located on a 1998 Oldsmobile intrigue?
passenger side of the motor must remove the serpentine belt there is a diagram on the left side of the motor compartment
Help on instaling a new timing belt for 1994 dodge shawdow?
You usally get instructions with a new belt. Its really simple, take right tire off, remove splash panel, remove crank pully, remove water pump belt idler. Need to loosen alt. to remove idler pully. also power steering belt. Remove ac pump leave hoses attached, remove ac pump bracket, also remove motor mount. remove timing belt covers, upper and lower. Align marks on cam, put motor on number 1 cyl, using marks on crank gear and dist. gear. install belt as per instructions. Asy. reverse of disasy.
How do you replace the water pump on a 1995 Mitsubishi Eclipse GS 2.0L 16 valve?
left front engine up, take timing belt cover off. Remove timing belt. remove bolts from water pump. but new water pump on. Set timing belt in the same position. But the timing belt and the pullies back on. Then your Finished. Looking at the repair manual this is a lot harder than it sounds because, u have to remove the motor mount to remove timing belt.
Where is the water pump located on a 1998 Pontiac Sunfire?
Answerwater pump for a 98 sunfire is located with the timing belt can be a job. have to remove front of motor. enj. mount ect. More: Unless the 98 is much different from my 96, the water pump has nothing to do with the timing belt. Also, there is no need to remove an engine mount bolt.You should be able to loosen the belt tensioner enough to get the belt on and off the pump pulley.
Where is the water pump located on a 1990 525i BMW?
The water pump is located in front of the motor ,behind the fan & partly under the timing belt cover. You have to remove the fan & shroud ,radiator hose's, dist cap, timing belt cover, and timing belt tensioner to remove it.The spring for the tensioner rest's on the pump, and there are three bolts that hold the pump to the block.
