I use a scan tool.
The first two steps are check the fluid and check the computer for trouble codes.
You need to have the trans computer checked for trouble codes. The car will not shift out of 2nd when the system detects a problem and sets a code.
Pulling a fuse will not clear codes on this vehicle. A scan tool is required to clear codes.
The system is finished displaying trouble codes in the odometer.
The first two steps are to check the fluid and check the computer for trouble codes.
A scan tool is preferred.
You have to use a scan tool.
With a scan tool.
The airbag light stays on when the computer has detected a malfunction and set a code. The codes need checked with a scan tool to know possible causes.
It will depend on the trouble codes. If they are circuit codes, you have a wiring problem. If they are other codes you could have a vacuum leak, stuck egr valve, or engine malfunction.
That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.
Chrysler does not have reset switches. You need to check for trouble codes with a scan tool.Chrysler does not have reset switches. You need to check for trouble codes with a scan tool.