answersLogoWhite

0

FIRST AND FOREMOST: IF YOUR AIR DIDN'T TURN FROM COLD TO NOT SO COLD TO COOL TO WARM AND SO ON, YOU MAY HAVE A LEAK. MINE WAS FREEZING ONE MINUTE AND THE NEXT DAY IT WAS HOT. TURNS OUT I HAD SNAPPED A REFRIGERANT LINE IN HALF. SO IF YOU LOST IT ALL OF A SUDDEN YOU'LL NEED TO PRESSURE TEST THE SYSTEM. Now The easiest way would be to buy a recharge kit at the auto parts store or even Walmart( think it's cheaper at Walmart) It will be the one that has the canister of R-134A and the hose with it. It will have instructions on the can basically telling you to turn your A/C on Max and all the way up. Make sure your car is at normal operating temp.There are two refrigerant lines. Because I have this same car I can tell you that the quick connect will only fit on one of the lines connectors. It is the line closest to the condensor up by the firewall. Shake the can real good before you hook it up. Connect the hose to the line and open the valve. Then tilt it back and forth 45% and agitate it by giving it a little shake. At the end of the bottle, turn it upside down to get the last bit then turn off the valve and disconnect from line. You should be good. (Technically you should probably check the specs on what the pressure should be then pressure test the system)

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the lower pressure port to recharge the ac on a 1987 Buick LeSabre?

it is on the passenger side of the engine compartment, and is part of the big silver accumilator.


How do you recharge your ac on your 2001 buick lesabre?

You would just need to make sure that the batter is charged. You can get a new battery or hook it up overnight in an outlet.


Where is the AC recharge valve located on a 1995 Buick Skylark?

The ac recharge port is the low side port. It is on the hoses on the passenger side of the engine close to the belts.


How do you install ac in 1995 Buick Lesabre?

To install air conditioning in a 1995 Buick LeSabre, first ensure you have all necessary components, including the AC compressor, condenser, evaporator, and associated hoses. Begin by removing any components obstructing access to the engine bay, then mount the compressor and connect the refrigerant lines. Install the condenser in front of the radiator, connect the evaporator to the cabin, and ensure all electrical connections are secure. Finally, recharge the system with refrigerant and test for proper operation.


Where is ac recharge on 2002 buick rendezvous?

On a 2002 Buick Rendezvous, the AC recharge port is located on the low-pressure side of the air conditioning system. To find it, open the hood and look for the AC lines; the low-pressure port typically has a larger diameter and is usually covered with a blue or black cap. It is usually found near the firewall or close to the compressor. Always ensure the system is off before attempting to recharge the AC.


How can you route the serpentine belt to bypass the AC compressor on a 1993 Buick lesabre What size belt do you use?

I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.


How do you fix a leak from the AC on a 2000 Buick LeSabre?

Un plug the drain which is on the firewall behind the right front tire.


Where is the AC recharge port on a 2004 Buick rendezvous?

The AC recharge port on a 2004 Buick Rendezvous is located in the engine compartment. Specifically, you'll find the low-pressure service port on the larger diameter aluminum line, typically near the firewall on the driver's side. To access it, you may need to remove a cover or some components for better visibility. Always ensure the engine is off and the AC system is properly diagnosed before attempting to recharge.


How do you recharge ac on 1996 Buick Century?

Connect a freon tank and gauge to the Buick Century low side ac port. Start the car and turn the ac to high. Open the tank and allow freon to flow. Shut the tank off when the gauge reads full.


Can you put a belt on your 1997 Buick leSabre without going on the AC Compressor?

You have to go on the compressor! My husband has a 95 and the auto parts manager told him you have to.


Why will the ac fan not work on 1999 buick lesabre?

Could be a number of issues, from mildew to coolant. You should ask a trusted service on diagnosing the issue.


How do you recharge ac unit for1989 Buick Reatta?

To recharge the AC unit of a 1989 Buick Reatta, first locate the low-pressure service port, which is typically found on the larger diameter aluminum line. Use a refrigerant recharge kit to connect the canister to the port. Follow the instructions on the kit, turning the canister upside down to allow the refrigerant to flow into the system while the AC is running on the maximum setting. Monitor the pressure gauge to avoid overcharging, and ensure the system is properly sealed to avoid leaks.