answersLogoWhite

0

The cables are part of the window regulator assemble. My cables jumped over the nylon pulley and kinked. Monster Auto Parts has the complete unit for 49.95. I going to get one and change it. It requires the use of the old motor if it's still good. Looks easy enough!

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove and reinstall a window on the drivers side?

First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.


How do you fix a 1998 Honda Civic driver side window which is off track?

Aligning a driver side window on a 1998 Honda Civic requires the removal of the door panel. With the door panel off move the window until it can properly align to the track. Once aligned slide the window into place and reinstall the door panel.


There are two cables hanging down in your door that go to the window and your window wont go up but the motor still works?

The regulator has failed and needs replaced.


How do you put up a power window that doesn't work?

Remove the door trim panel.Then clip the window regulator cables. Push window up and tape it in place until you can replace the regulator


How do you change drivers side window motor on 95 Chevy truck?

1. Remove door panel, and disconnect the door harness. 2. Unbolt window from the rail, remove the window from the door. 3. Unbolt old motor and remove. 4. Using a window motor tool, (if you don't use one you could risk having the lifting frame on the motor uncoil and injure your hand or wrist), remove the motor from the lifting frame. 5. Using the supplied hardware install the new motor into the frame. 6. Install new motor in the door. 7. Reinstall the glass. 8. Reconnect the harness.(make sure window works) 9. Reinstall the door panel.


How do you put an electric window back on track on a 1999 Olds Alero when it is all the way down inside the front passenger door?

take off inner door panel, lower track and put the window back in. If parts on track are broken buy new ones. Use urathain to reinstall window.


Were can you buy the rear latch cables that open the door and window on a 97 ford expedition?

Try your local junk yards, or your local dealer.


Can you show me where the door to the closet is located in this room?

The closet door is on the right side of the room, next to the window.


How do you unblock the gift shop door on club penguin?

you go through the window above p.s. its the right window


How do you replace a power window motor on a 1990 corvette?

door panel will have to come off and more than likely the motor has rivets holding it in place so the complete window regulator will have to be taken out of the door and the rivets drilled out to get the motor off and then reinstall new motor with bolts and nuts.


How do you fix cable in drivers door so the electric window of 1997 dodge caravan will work?

If the cables have failed, the entire regulator needs replaced.


Where is the VIN on the Mitsubishi l200?

either on the door or right below the front window