use a pry bar between the ideler arm and pully. The tensioner is sprig activated. This will take a little pressure, but it should loosen with eaze. after releaseing tensioner, it will tighten back up b/c of the spring.
Release the pressure on the belt tensioner and belt should slide off pulleys
you have to put a socket wrench into the hole on the tensioner and pull up on it to release the tension from the belt.
To release the auto tensioner on a serpentine belt for a 2003 Acura MDX, use a socket wrench to turn the tensioner pulley counterclockwise. This will relieve tension on the belt, allowing you to slide it off the pulleys. Once the belt is removed, you can slowly release the tensioner back to its original position. Always ensure you have the correct tools and follow safety precautions when working on your vehicle.
The 2.2 ecotec motor has a timing chain with oil pressure tensioner and chain guides.
Its on a spring loaded tensioner. Usually a wrench or socket extension(square) will be able to let you turn the tensioner to release the tension on the belt
I believe the data link connector in a 2003 Ford Ranger is below the steering wheel , behind a small removable plastic panel in the dash , located between the inside hood release and the parking brake release
Where is the belt tensioner on a ford 2003 f350 6l diesel? i need to loosen so that i can replace the alternater
Ya what about it??? 2003 ford ranger got an extented cab... if that's what ur hoping!!
Animal Cops Houston - 2003 Under Pressure was released on: USA: 3 November 2006
The Critical Hour - 2003 Grace Under Pressure 1-10 was released on: USA: 9 March 2003
near the belt
yes.