On the drums there are two holes. You need to insert two to bolts (size 10 metric) in to the holes as yoo tighten the bolts it pushes the drum off. bolts need to be about 3 inches long. i could be wrong about the bolt size
Most of them are located inside the brake drums.
How do you. Bleed tear brake
If you are inexperienced, you should not be messing around with the brake drums.
brake drums should pull off if not rusted on.
Remove the wheels, pry the drums off.
Remove the drums and take them to an auto parts store that has a brake drum lathe.
Remove the wheels from your 1995 Toyota Camry. Remove the brake pads by removing the brake pad Springs. Tap on the brake drum with a hammer or mallet. Slide the brake drums off. Reverse the process to install the new brake drums and shoes.
To remove the rear brake drums from a 1969 Chevrolet C-60 Viking truck, first, ensure the vehicle is securely lifted and supported on jack stands. Remove the wheel lug nuts and take off the wheels. Next, locate the brake drum retaining screws (if present) and remove them, then gently tap the drum with a hammer to break it loose, as it may be rusted or stuck. Finally, slide the drum off the wheel hub while ensuring the brake shoes are not catching on the drum's edges.
experience and a big hammer
very carefully :)
first you have to take the wheels off of the van,and then you have to take the tension off of the brake shoes. Next you will be able to remove the rear brake drums off of the vehicle.You may have to tap them with a hammer to break them free.
No, the drums can be cleaned with brake cleaner.No, the drums can be cleaned with brake cleaner.